
Operating Instructions
Notes
•Some wireless devices do not support the WEP 152 bit.
•The camera supports only the open system authentication. If the wireless router or access point is set to shared key authentication, set it to auto or open system.
4.Click [Save] when finished.
•New settings are saved.
•When finished, "Success!" is displayed.
5.Click [Go to Wireless configuration page].
•The Wireless page is displayed.
6.Set the switch to WIRELESS.
Notes
•Encryption is a help to protect data within wireless LAN from third parties.
•Enter both the MAC addresses for the camera itself and the camera's wireless module to enable the MAC address filtering feature on the wireless router. The wireless module MAC address is one value higher than the camera MAC address.
•It takes about 1 minute for the new settings to be effective.
•It is not possible to access the camera simultaneously by both wired and wireless connection.
•To communicate using wireless connection, set up the camera by using wired connection and set the switch from wired to wireless as shown below.
< Bottom >
Switch
WIRELESS WIRED
38