4.Attach the unit to the mounting bracket.
You need to make a hole of approx. ø 30 mm on the wall to pass the cables out of the rear side.
(1) Attach the mounting bracket to the wall.
(2)Remove the numeric keyboard.
1 | 2 | 3 |
|
|
|
|
| 4 | 5 |
| |
|
|
| CANCEL | ||
|
|
|
| ||
|
|
|
|
|
Coaxial cable and
| DC power cable * | Provide access for |
| cables to be routed | |
| (from the control unit) | |
| through the wall. | |
|
| |
| (3) Remove the shipping lock. |
|
| (4) Attach the unit to the mounting bracket. | |
| Secure the unit and bracket with the screw nut, | |
Screw nut (M5) | using an 8 mm {0.03 in.} socket driver. | |
(5)Connect the cables to the unit.
(6)Attach the numeric keyboard.
*Refer to the control unit’s operating instructions for the specifications.
5.Connect the coaxial cable to the unit.
The unit is connected to the control unit (Camera 1 - 3).
Coaxial cable
To CAMERA 1 - 3 of the control unit
6.When you use the
Connect them.
Pass the cable through this hole.
7.Connect the DC power cable to the unit.
If you use power supply from the control unit to the unit, connect the DC power cable to 0 V and +32 V ports.
If you use 24 V DC power supply from an external power supply device, connect the power cable to 0 V and +24 V ports.
Pass the cable through this hole.
To the control unit
0 V +24 V +32 V
Caution: Take DC 24 V power supply from a
8.Attach the numeric keyboard.
Connect the control cable which has been connected to the numeric keyboard. Then, attach the keyboard with the tamperproof screws.
Caution: Insert the cable into the unit so as to avoid pressure from the keyboard.
To a monitor or digital disk recorder
13