Before using
(38)
(38)Tripod receptacle
This is a hole for attaching the camera to optional
≥When the tripod is used, operate the camera from the free style remote control for convenience. (When not using the remote control, attach the clip to the grip belt for convenience. When you move with remote control attached to a pocket, etc., take care to avoid falling of the tripod.)
≥You cannot open the card slot cover when the tripod is used. Insert the card first and then attach the tripod.
(39)
(39)Shoulder strap fixture
1
3
2
≥Put the strap through the fixture 1 and through the stopper 2 so it will not come off. Extend part 3 by at least 2 cm.
≥Fit the other end of the belt similarly.
1
2
(40)
(40)Lens hood
In order to remove the lens hood, rotate it counterclockwise 1. In order to fit it, put into slot 2, and then rotate it clockwise.
≥Fit the MC protector or the ND filter of the Filter Kit
hood. (Except for the lens cap) ≥When fitting the tele conversion lens
≥When 2 lens accessories, such as the ND filter and tele conversion lens, are fitted and the [W/T] lever is pressed toward the [W] side, the 4 corners of an image will be darkened. (Vignetting)
Fitting the lens cap
Fit the lens cap to protect the surface of the lens. If you do not use the movie camera when the MC protector or the ND filter of the Filter Kit
1Remove the grip belt. Run the end of the lens cap cord through the hole in the grip belt attachment part and run the lens cap through the lens cap cord.
≥The lens cap removed can be hung on the lens cap fixture. (It cannot be hung if the grip belt is used as a hand strap.)
≥To fit or remove the lens cap, hold both sides of the lens cap with the tips of your first 2 fingers.
7
VQT0N57