Panasonic NV-GS75EB operating instructions Free style remote control, Remote control usable range

Page 17

Before using

WARNING

“THE LITHIUM BATTERY IS A CRITICAL COMPONENT (TYPE NUMBER CR2025

MANUFACTURED BY PANASONIC). IT MUST NEVER BE SUBJECTED TO EXCESSIVE HEAT OR DISCHARGE. IT MUST THEREFORE ONLY BE FITTED IN EQUIPMENT DESIGNED SPECIFICALLY FOR ITS USE.

REPLACEMENT BATTERIES MUST BE OF THE SAME TYPE AND MANUFACTURER. THEY MUST BE FITTED IN THE SAME MANNER AND LOCATION AS THE ORIGINAL BATTERY, WITH THE CORRECT POLARITY CONNECTIONS OBSERVED.

DO NOT ATTEMPT TO RE-CHARGE THE OLD BATTERY OR RE-USE IT FOR ANY OTHER PURPOSE. IT SHOULD BE DISPOSED OF IN WASTE PRODUCTS DESTINED FOR BURIAL RATHER THAN INCINERATION.”

ªRemote control usable range

The distance between the remote control and the camera: Within approx. 5 m

Angle: Approx. 10o up and 15o down, left, and right

ªSelecting the remote control mode

If 2 cameras are used simultaneously, set the mode for one pair of movie camera and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].)

1 Setting on the camera:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2 Setting on the remote control:

STILL ADV PAUSE STILL ADV

VOL

2

1

 

STOP

VAR

[VCR1]:

Press [D] and [] simultaneously. 1

[VCR2]:

Press [E] and [] simultaneously. 2

ªConcerning the button-type battery

When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation frequency.

Keep the button-type battery out of the reach of children.

If the remote control mode of the camera and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the camera is turned on, “CHECK REMOTE

MODE” (-45-) will appear and operation is impossible. Set the same remote control mode.

The remote control is intended for indoor operation. Outdoors or under strong light, the movie camera may not operate properly even within the usable ranges.

Within a 1 metre range, you can operate the remote control from beside the remote control sensor (LCD monitor side) of the movie camera.

Free style remote control

This controller can be used from different high and low angles. It is also handy when a tripod is used. When you do not use the controller, attach the clip to the grip belt. Left-handed users can use this camera more easily.

(1)

(2)

(3)

(1)Recording start/stop button [REC]

(2)Zoom lever [W/T]

(3)Photoshot button [PHOTO SHOT]

ªConnect the free style remote control

to the camera

1Plug the free style remote control into the [REMOTE] terminal as far as it goes.

REMOTE/MIC

17

VQT0N57

Image 17
Contents Operating Instructions How to replace the Fuse Information for Your SafetyBefore Use AC AdaptorFiles recorded on a SD Memory Card Carefully observe copyright lawsPages for reference Menu operation flow is indicated by in the descriptionContents Accessories Before usingOptional Parts identification and handlingViewfinder -9 Audio-video output terminal AVUSB terminal Speaker Tripod receptacle Fitting the lens capShoulder strap fixture Lens hoodTo restore the strap to the grip belt Using the LCD monitorOne-touch free-style grip belt To use as a hand strapPower supply Using the viewfinderCharging time and recordable time Removing the batteryInserting/removing a cassette Slide the OPEN/EJECT lever and open the cassette coverInserting/removing a card Turning the camera on Selecting a modeHow to use the joystick Tape playback mode Tape recording mode AUTO/MANUAL/FOCUS switch is set to AutoCard recording mode AUTO/MANUAL/FOCUS switch is set to Auto Tele-macro Soft skin mode Backlight compensationUsing the menu screen Switching the languageAdjusting LCD monitor/viewfinder Setting date and timeInstall a button-type battery Using the remote controlRemote control Remote control usable range Free style remote controlSelecting the remote control mode Concerning the button-type batteryAbout the clip on the backside Check before recording Record modeConcerning the remaining tape time Indication on the screen On-screen display in the tape recording modeRecording on a tape Blank search function Check the recordingRecording still pictures onto a card Photoshot Stopping blank search midway ThroughZoom in/out function Recording yourself To cancel the quick start when Power is OFFQuick start To use the zoom microphone functionNight view functions Soft skin modeBacklight compensation function Wind noise reduction function Tele-macro functionFade in/fade out function Image stabilizer function Self-timer recordingRecording images for wide-screen TVs To cancel the scene mode function Recording in various situations Scene modeContinuous Photoshot To stop continuous photoshot Midway throughRecording in natural colours White balance To restore to automatic adjustment Manual focus adjustmentManual shutter speed/aperture adjustment 50-1/8000 seconds Tape Recording Mode Manual iris/gain adjustmentShutter speed range Iris/gain value rangeSlow-motion playback/ frame-by-frame playback Playback modePlaying back tape Playback on TV Variable-speed search functionTo return to normal playback Frame-by-frame playbackTo display the on-screen information On the TV Playing back cardTo display multiple playback files About the compatibility of still picturesDeleting files recorded on a card To complete the settingsFormatting a card Protecting files on a cardWhat is DPOF? Writing the printing data on a card Dpof settingSelect Cancel ALL in Step To set so that all pictures are not PrintedCopying onto a DVD recorder or a VCR Dubbing Edit modeRecording from a tape onto a card Audio dubbing Using the DV Cable for Recording Digital DubbingYou can add music or narration to the recorded cassette ≥Talk into the microphoneTo play back the sound recorded with Audio dubbing Before recording with audio dubbingTo dub audio while listening to a Pre-recorded sound USB cableSelect the setting for date printing When you stop printing halfwaySelect the desired number of prints Select the paper sizeMenu list MenuTape Recording Menu Tape Playback MenuBasic DATE/TIME -42-PROTECT Card Recording MenuPicture Playback Menu Menus related to playback Menus related to taking picturesInitial SET Demo ModeOther menus Indications OthersTextual indications Confirmatory indicationsCheck the connected printer Functions cannot be used simultaneouslyThere is no paper. Check the connected printer Power/Body Movie camera power cannot be turned on Before requesting repair Problems and solutionsMovie camera power is turned off automatically Movie camera power does not stay on long enoughCassette cannot be removed Remote control does not functionNo operation other than cassette removal can be performed Screen has changed suddenlyPush the Reset Switch is displayed Original sound was erased when audio dubbing was performedAudio dubbing cannot be performed Sounds cannot be played backAbout condensation About dirty heads Seconds later ≥We recommend cleaning the heads periodicallyAbout the movie camera ≥If the movie camera is sprayed with suchAbout the cassette About the batteryAbout the AC adaptor Folder structure of the card About the cardLCD monitor/viewfinder Periodical check-upsAutomatic white balance Explanation of termsWhite balance Auto focusSpecifications SpecificationsSpecifications AC adaptor VQT0N57 VQT0N57 Numerics IndexF1204Ke0 10000 a