Before using
VAR.
SEARCHMENU
ENTER
3Press the [MENU] button to exit the menu screen.
VAR.
SEARCHMENU
ENTER
Setting date and time
If the screen shows the incorrect date/time, then adjust it.
≥Set to Tape Recording Mode or Card
Recording Mode.
1Set [BASIC] >> [CLOCK SET] >> [YES].
2Move the joystick left or right in order to select the item to be set. Then move the joystick up or down to set the desired value.
≥The year will change as follows: 2000, 2001, ..., 2089, 2000, ...
≥The
3Press the joystick to determine the setting.
≥The clock function starts at [00] seconds.
ªAbout date/time
≥The date and time function are driven by a built- in lithium battery.
≥Make sure to check the time before recording because the
ªRecharging the built-in lithium battery
≥If [0] or
WARNING
THE LITHIUM BATTERY IN THIS EQUIPMENT MUST ONLY BE REPLACED BY QUALIFIED PERSONNEL. WHEN NECESSARY, CONTACT YOUR LOCAL PANASONIC SUPPLIER.
Adjusting LCD monitor/viewfinder
ªAdjusting the brightness and colour
level
1Set [SETUP] >> [LCD SET] or [EVF SET] >> [YES].
2Move the joystick up or down in order to select the item to be adjusted.
[LCD SET]
:Brightness of the LCD monitor
:Colour level of the LCD monitor [EVF SET]
EVF :Brightness of the viewfinder
3Move the joystick left or right to move the bar indication representing the brightness.
4Press the [MENU] button or the joystick to complete the settings.
≥In order to adjust the brightness of the viewfinder, close the LCD monitor, and the
viewfinder will be activated.
≥When the LCD monitor is rotated by 180° towards the lens, the brightness of the LCD monitor cannot be adjusted.
≥These settings will not affect the images actually recorded.
ªIn order to increase the brightness of
the entire LCD monitor
1Press the [POWER LCD] button.
POWER LCD
≥The [POWER LCD] lamp lights up.
15
VQT0N57