Edit mode
≥If you record (dub) images onto another video device and then play them back on a wide- screen TV, the images may be stretched vertically. In this case, refer to the operating instructions for the device that you are recording (dubbing) to or read the operating instructions
for the TV and set to 16:9 (full).
≥For more information, refer to the operating instructions for your TV set and recorder.
≥When you do not need functional indications or date and time indication, respectively set [SETUP] >> [DISPLAY] >> [OFF] or set [BASIC]
>>[DATE/TIME] >> [OFF] in the Tape Playback Mode.
(When you connect the Camcorder and a recorder with the DV cable, these indications may not appear.)
ªWhen neither image nor sound from the Camcorder is output to the TV set
≥Check that the plugs are inserted as far as they go.
≥Check the [12bit AUDIO] settings.
Using the DV Interface Cable for Recording (Digital Dubbing)
By connecting other digital video equipment with DV terminal and the Camcorder by using the DV cable
≥Set to Tape Playback Mode. (Player/recorder)
1Connect the Camcorder and digital video equipment with the DV cable.
1
2Set [ADVANCED] >> [REC STDBY] >> [YES]. (Recorder)
3Start playback. (Player)
4Start recording. (Recorder)
Move the joystick up to select [¥/;] icon.
5Move the joystick up to select the [¥/;] icon again to stop recording. (Recorder)
6Stop playback. (Player)
ªTo cancel the standby for recording
When the Camcorder is standby for recording, move the joystick down and select the [∫] icon.
≥Do not plug or unplug the DV cable during dubbing or the dubbing may not be completed properly.
≥If a picture (bilingual video, etc.) containing main sound and sub sound has been dubbed, select the desired sound by [SETUP] >> [AUDIO OUT]
on playback.
≥Even if you use a device equipped with DV terminals such as IEEE1394, you may not be able to perform digital dubbing in some cases. For more information, see the instructions for equipment connected.
44