Others
Before requesting repair (Problems and solutions)
Power/Body
1:The Camcorder power cannot be turned on.
•Is the battery fully charged? Use a fully charged battery.
•The battery protection circuit may have operated. Attach the battery to the AC adaptor for 5 to 10 seconds. If the Camcorder still cannot be used, the battery is faulty.
•Is the LCD monitor opened or the viewfinder extended?
2:The Camcorder power is turned off automatically.
•If you set [POWER SAVE] to [5 MINUTES] and do not operate the Camcorder for about
5 continuous minutes, the power is automatically turned off for tape protection and power conservation. To resume recording, turn the [OFF/ON] switch to [OFF]. Then turn it to [ON] again.
[POWER SAVE] to [OFF], the power does not
automatically turn off.
3:The Camcorder power does not stay on long enough.
•Is the battery low? If the remaining battery power indication is flashing or the message “LOW BATTERY” is displayed, the battery has run down. Charge the battery or attach a fully charged battery.
•Has condensation occurred? When you carry the Camcorder from a cold place into a warm place, condensation may occur inside it. If so, the power is turned off automatically, disabling all operations except for taking cassettes out. Wait until the condensation indication
disappears.
4:Battery runs down quickly.
•Is the battery fully charged? Charge it with the AC adaptor. (-12-)
•Are you using the battery in an extremely cold place? The battery is affected by ambient temperature. In cold places, the operating time of the battery becomes shorter.
•Has the battery worn out? The battery has a limited life. If the operating time is still too short even after the battery is fully charged, depending on the usage, the battery has worn
out and can no longer be used.
5:The Camcorder cannot be operated though powered up.
The Camcorder does not operate normally.
•The Camcorder cannot be operated unless you open the LCD monitor or extend the viewfinder.
60
•Remove the cassette and the card and then press the [RESET] button.
data on the card.)
6:The cassette cannot be removed.
•Does the status indicator comes on when opening the cassette cover?
•Is the battery in use discharged? Charge the battery and remove the cassette.
•Close the cassette cover completely and fully
open it again.
7:No operation other than cassette removal can be performed.
•Has condensation occurred? Wait until the condensation indication disappears.
Recording
1:Recording doesnot start although poweris suppliedtotheCamcorderand thecassette is correctly inserted.
•Is the accidental erasure prevention slider on the cassette open? If it is open (set to [SAVE]), recording cannot be performed.
•Is the tape wound to the end? Insert a new cassette.
•Is the recording mode set? When in the playback mode, recording cannot be performed.
•Has condensation occurred? No operation other than cassette removal can be performed when condensation occurs. Wait until the condensation indication disappears.
•Is the cassette cover open? If the cover is open, the Camcorder may not operate
normally. Close the cassette cover.
2:The screen has changed suddenly.
•Has the demonstration started? In the Tape Recording mode, if you set [DEMO MODE] >> [ON] without inserting a cassette and a card, the demonstration starts. For normal use, set
this function to [OFF].
3:A cassette cannot be inserted.
• Has condensation occurred? Wait until the condensation indication disappears.
4:Auto focus function does not work.
•Is manual focus mode selected? If auto focus mode is selected, focus is automatically adjusted.
•There are some recording subjects and surroundings for which the auto focus does not operate correctly.