Panasonic PV-GS80 To cancel Quick Start, Open the LCD monitor or extend the Viewfinder

Page 18

Before using

Quick Start

When Quick Start is ON the battery power is still being consumed, even when the LCD Monitor and the Viewfinder are closed.

The Camcorder will resume recording/pause mode about 1.7 seconds after the LCD Monitor and the Viewfinder are reopened.

≥Please note in Quick Start Mode approximately half the pause recording power is being consumed.

Using Quick Start Mode will reduce the battery recording/playback time.

≥This is only activated in the following cases. ≥While using the battery

A tape or a card is inserted while Tape Recording Mode is set.

A card is inserted while Card Recording Mode is set.

≥While using the AC adaptor

Quick Start can be used even if a tape/card is not inserted.

≥Set to Tape/Card Recording Mode.

1Set [SETUP] >> [QUICK START] >> [ON].

(-23-)

2While the [OFF/ON] switch is still set to [ON], close the LCD monitor and retract the Viewfinder.

OFF

ON

≥The Status indicator lights green and the unit goes into quick start standby mode.

≥The Camcorder will not go into quick start standby mode unless the LCD monitor is closed and the viewfinder is retracted.

3Open the LCD monitor or extend the Viewfinder.

OFF

ON

≥The Status indicator lights red and the Camcorder is put into recording pause approx. 1.7 seconds after it is turned on.

ªTo cancel Quick Start

1Set [SETUP] >> [QUICK START] >> [OFF].

(-23-)

≥If the [OFF/ON] switch is set to [OFF] while the unit is in quick start standby mode, the power turns off.

≥If the standby continues for approx. 30 minutes, then the Status indicator will go off and the Camcorder will be completely turned off.

≥In the following cases, quick start is canceled and the power turns off.

≥When the Mode dial is moved.

≥When the battery or AC adaptor is removed. ≥When both the tape and card are removed while using the battery in Tape Recording

Mode.

≥When the card is removed while using the

battery in Card Recording Mode.

≥When the Camcorder is quick-started with the white balance on automatic, it may take some time until the white balance is adjusted if the scene being recorded has a light source different from the scene last recorded. (When the MagicPix function is used, however, the white balance of the scene last recorded is retained.)

≥If the power is turned on in quick start standby mode, the zoom magnification becomes 1t and the picture size may differ from what it was before quick start standby.

≥If [POWER SAVE] (-28-) is set to [5 MINUTES] and the unit automatically goes into quick start standby mode, set the [OFF/ON] switch to [OFF], then to [ON] again. Also, close the LCD monitor and retract the viewfinder and then open the LCD monitor or extend the viewfinder again.

18

LSQT1121

Page 17 Page 19
Image 18
Page 17 Page 19
Contents PV-GS80 Things You Should Know Following Applies only in the U.S.A Important Safety Instructions This symbol is only valid in the European Union Battery pack Lithium ion battery pack≥Use the specified unit to recharge the battery pack AC adaptor This AC adaptor operates on AC between 110/120/220/240 ButContents With a PC Playback modeEdit mode MenuHow to turn on the power Charging the batteryAttaching the battery Quick GuideRecording still pictures onto a card How to turn off the powerRecording on a tape Playing back tapeParts identification and handling AccessoriesBattery pack AV cable USB cable PV-GS85 only CamcorderViewfinder -17 Attaching the lens cap How to remove the Sensor tag for U.S.A. onlyAdjust the belt length and the pad position Grip beltRemoving the battery Power supplyConnecting to the AC outlet Charging lamp≥Set the OFF/ON switch to OFF when not using the Camcorder Charging time and recordable timeTurning the Camcorder on Setting date and time Recharging the built-in lithium batteryAbout date/time Adjusting the field of view Using the LCD monitorUsing the viewfinder Extending the viewfinderQuick Start To cancel Quick StartSet Setup Quick Start OFF Open the LCD monitor or extend the ViewfinderInserting/removing a cassette When the cassette holder does not Come outWhen the cassette holder cannot be Housed Accidental erasure preventionInserting/removing a card Card access lampConcerning the write protection Switch on the SD Card Concerning the cardBasic joystick operations Selecting a modeHow to use the joystick Joystick and screen displayTape playback mode Playback the previous pictureUsing the menu screen Help modeSwitching the language To exit the Help modeAdjusting the brightness and color Level Adjusting LCD monitor/viewfinderAbout the menu setting To exit the menu screenRecording with the built-in LED video light Press the Light button ≥The gain up mode is set to off≥To eliminate washed out images, use this mode Press the Light buttonCheck before recording About auto modeRecording mode Basic Camcorder positioningOn-screen display in the tape recording mode Recording on a tapeConcerning the remaining tape time Indication on the screen Recording check Power SaveOFF When 5 minutes passes without Blank search functionRecording a still picture on a tape Photoshot To record still pictures clearly On-screen display in the card recording modeRecording still pictures onto a card Select the picture quality for Photoshot imagesAbout the variable speed zoom Function Zoom in/out functionDigital zoom function To use the zoom microphone functionBacklight compensation function To cancel the MagicPix functionRecording yourself MagicPix functionTo cancel fading Soft skin modeTo cancel the soft skin mode Fade in/fade out functionTo stop the timer midway through Self-timer recording PV-GS85 onlyTo cancel the wind noise reduction Function Wind noise reduction functionWide/43 function Optical image stabilizer functionGuideline function Recording in various situations Scene mode To cancel the scene mode functionTo set the white balance manually To restore to the automatic AdjustmentRecording in natural colors White balance About flashing of the indicationManual focus adjustment Manual shutter speed/aperture adjustmentTo restore to automatic adjustment Manual iris/gain adjustment Shutter speed rangeIris/gain value range Playing back tape To adjust volumeSettings on the audio Repeat playbackFrame-by-frame playback Playback on TVTo return to normal playback To display multiple playback files Move the s /VOLr lever to switch the imagesPlaying back card PV-GS85 only About the compatibility of still picturesTo delete all files Deleting files recorded on a cardFormatting a card PV-GS85 only Move the joystick down to selectWhat is DPOF? Writing the printing data on a card Dpof settingTo complete the settings Protecting files on a cardCopying onto a DVD recorder or a VCR Dubbing Edit modeRecording from a tape onto a card ≥The image and sound are reproducedUsing the DV Interface Cable for Recording Digital Dubbing To cancel the standby for recordingStop playback. Player PC Connection with the DV Interface Cable Using the Built-in SD Drive Connecting Computer CamcorderUsing on a Windows PC PV-GS85 only Operating environmentUsing as a Web camera Re-start the computer after the USB Driver is installed Installing USB Driver≥The setup program starts running Usual operation WEB Camera mode Tape Playback ModeClick Sign Type in your Sign-in name and password Setting up Windows MessengerSetting up MSN Messenger Windows Live Messenger ≥Windows Messenger is activatedUsing on Macintosh Operating environment on iMovie IMovie HDCopying still pictures on PC To disconnect USB cable safely If you no longer need the driver Uninstall≥When Mode Dial is turned to change modes Double clickAbout the compatibility of the card Mode of the Camcorder and reconnect the cableAbout the SD Card Files recorded on a SD CardComputer PV-GS85 only 256Menu list Tape Recording MenuTape Playback Menu Advanced O.I.S. -35-GUIDE Lines -35-SHTR Effect Card Recording MenuCard Playback Menu PV-GS85 only Basic DATE/TIME -58-PROTECTMenus related to recording Menus related to playbackOther menus Recording indications IndicationsBasic indications Playback indicationsConfirmatory indications Textual indicationsFunctions Conditions which disable Functions that cannot be used simultaneouslyBefore requesting repair Problems and solutions Playback Pictures Remaining tape time indication disappearsDifferent sounds are reproduced at the same time Playback images are verticalPhotoshot playback images do not look normal Push the Reset Switch is displayedCard PV-GS85 only Recorded pictures are not clear Even if a card is formatted, it cannot be usedAbout dirty heads When the lens is foggedAbout condensation Remove the tape if it is insertedAbout the Camcorder About the batteryBe sure to detach the battery after use While carrying the Camcorder, do not drop or bump itAbout the AC adaptor About the cassetteAbout the card PV-GS85 only LCD monitor Folder structure of the cardPeriodical check-ups ViewfinderWhite balance Explanation of termsAutomatic white balance Auto focusSpecifications Http//panasonic.co.jp/pavc/global/cs169 Camcorder Accessory System Accessory# DescriptionCamcorder Accessory Order Form For USA Customers VisaRequest for Service Notice Request for Service Notice USA OnlyPanasonic Video Products Centralized Factory Service Center Customer Services DirectoryAccessory Purchases Npcparts@us.panasonic.comCamcorder Product One 1 year, parts and labour Warranty For Canadian CustomersAmbler Drive, Mississauga, Ontario L4W 2T3 For Product Operation ASSISTANCE, please contactIndex NumericsSpanish Quick Use Guide Guía española para el uso rápido Grabación de imágenes fijas en una Cómo apagar la alimentaciónGrabación en una cinta Reproducción de la cintaLSQT1121 LSQT1121 LSQT1121 Panasonic Puerto Rico, Inc
Related manuals
Manual 81 pages 30.22 Kb
Top Page Image Contents