Panasonic PV-GS80 Setting date and time, About date/time, Recharging the built-in lithium battery

Page 16

Before using

ªHow to turn the power on and off with

the LCD monitor/viewfinder

When the power switch is set to [ON], the power can be turned on and off with the LCD monitor and the viewfinder when the unit is in Tape Recording Mode or Card Recording Mode.

OFF

ON

1Open the LCD monitor out or extend the viewfinder to use. (-17-)

≥The LCD monitor or viewfinder will be activated.

2Close the LCD monitor and retract the viewfinder.

OFF

ON

≥The power will not turn off unless the LCD monitor is closed and the viewfinder is retracted.

≥The Status indicator automatically goes off and the power turns off. (If quick start is set to [ON] (-18-), the unit goes into quick start standby mode and the Status indicator lights green.)

≥The power does not turn off even if the

LCD monitor is closed and the viewfinder is retracted while recording on a tape.

3Open the LCD monitor or extend the viewfinder to turn the power on and use the Camcorder again.

OFF

ON

≥The Status indicator lights red and the power turns on.

Setting date and time

When the Camcorder is turned on for the first time, [SET DATE AND TIME] will appear.

≥Select [YES] and press the center of the joystick. Perform steps 2 and 3 below to set the date/time.

If the screen shows the incorrect date/time, then adjust it.

≥Set to Tape Recording Mode or Card

Recording Mode.

1Set [BASIC] >> [CLOCK SET] >> [YES]. (-23-)

2Move the joystick left or right in order to select the item to be set. Then move the joystick up or down to set the desired value.

≥The year will change as follows: 2000, 2001, ..., 2089, 2000, ...

≥The 12-hour clock is used.

3Press the joystick to determine the setting.

≥The clock function starts at [00] seconds.

ªAbout date/time

≥The date and time function are driven by a built- in lithium battery.

≥Make sure to check the time before recording because the built-in clock is not very accurate.

ªRecharging the built-in lithium battery

≥If [0] or [--] appears when the Camcorder is turned on, then the built-in lithium battery has run down. Use the steps below to charge the battery. When turning on the power for the first time after charging, [SET DATE AND TIME] will appear. Select [YES] and set the date and time. Connect the AC adaptor to the Camcorder or attach the battery to the Camcorder, and the built-in lithium battery will be recharged. Leave the Camcorder as is for approx. 24 hours, and the battery will drive the date and time for approx. 6 months. (Even if the [OFF/ON] switch is set to [OFF], the battery is still being recharged.)

16

LSQT1121

Page 15 Page 17
Image 16
Page 15 Page 17
Contents PV-GS80 Things You Should Know Following Applies only in the U.S.A Important Safety Instructions Battery pack Lithium ion battery pack This symbol is only valid in the European Union≥Use the specified unit to recharge the battery pack AC adaptor This AC adaptor operates on AC between 110/120/220/240 ButContents Playback mode Edit modeWith a PC MenuCharging the battery Attaching the batteryHow to turn on the power Quick GuideHow to turn off the power Recording on a tapeRecording still pictures onto a card Playing back tapeAccessories Battery pack AV cable USB cable PV-GS85 onlyParts identification and handling CamcorderViewfinder -17 How to remove the Sensor tag for U.S.A. only Adjust the belt length and the pad positionAttaching the lens cap Grip beltPower supply Connecting to the AC outletRemoving the battery Charging lampCharging time and recordable time ≥Set the OFF/ON switch to OFF when not using the CamcorderTurning the Camcorder on Recharging the built-in lithium battery Setting date and timeAbout date/time Using the LCD monitor Using the viewfinderAdjusting the field of view Extending the viewfinderTo cancel Quick Start Set Setup Quick Start OFFQuick Start Open the LCD monitor or extend the ViewfinderWhen the cassette holder does not Come out When the cassette holder cannot be HousedInserting/removing a cassette Accidental erasure preventionCard access lamp Concerning the write protection Switch on the SD CardInserting/removing a card Concerning the cardSelecting a mode How to use the joystickBasic joystick operations Joystick and screen displayTape playback mode Playback the previous pictureHelp mode Switching the languageUsing the menu screen To exit the Help modeAdjusting LCD monitor/viewfinder About the menu settingAdjusting the brightness and color Level To exit the menu screenPress the Light button ≥The gain up mode is set to off ≥To eliminate washed out images, use this modeRecording with the built-in LED video light Press the Light buttonAbout auto mode Recording modeCheck before recording Basic Camcorder positioningRecording on a tape On-screen display in the tape recording modeConcerning the remaining tape time Indication on the screen Power Save OFF When 5 minutes passes withoutRecording check Blank search functionRecording a still picture on a tape Photoshot On-screen display in the card recording mode Recording still pictures onto a cardTo record still pictures clearly Select the picture quality for Photoshot imagesZoom in/out function Digital zoom functionAbout the variable speed zoom Function To use the zoom microphone functionTo cancel the MagicPix function Recording yourselfBacklight compensation function MagicPix functionSoft skin mode To cancel the soft skin modeTo cancel fading Fade in/fade out functionSelf-timer recording PV-GS85 only To cancel the wind noise reduction FunctionTo stop the timer midway through Wind noise reduction functionOptical image stabilizer function Wide/43 functionGuideline function Recording in various situations Scene mode To cancel the scene mode functionTo restore to the automatic Adjustment Recording in natural colors White balanceTo set the white balance manually About flashing of the indicationManual shutter speed/aperture adjustment Manual focus adjustmentTo restore to automatic adjustment Shutter speed range Manual iris/gain adjustmentIris/gain value range To adjust volume Settings on the audioPlaying back tape Repeat playbackPlayback on TV Frame-by-frame playbackTo return to normal playback Move the s /VOLr lever to switch the images Playing back card PV-GS85 onlyTo display multiple playback files About the compatibility of still picturesDeleting files recorded on a card Formatting a card PV-GS85 onlyTo delete all files Move the joystick down to selectWriting the printing data on a card Dpof setting To complete the settingsWhat is DPOF? Protecting files on a cardEdit mode Recording from a tape onto a cardCopying onto a DVD recorder or a VCR Dubbing ≥The image and sound are reproducedTo cancel the standby for recording Using the DV Interface Cable for Recording Digital DubbingStop playback. Player PC Connection with the DV Interface Cable Connecting Computer Camcorder Using on a Windows PC PV-GS85 onlyUsing the Built-in SD Drive Operating environmentUsing as a Web camera Installing USB Driver ≥The setup program starts runningRe-start the computer after the USB Driver is installed Usual operation WEB Camera mode Tape Playback ModeSetting up Windows Messenger Setting up MSN Messenger Windows Live MessengerClick Sign Type in your Sign-in name and password ≥Windows Messenger is activatedOperating environment on iMovie IMovie HD Using on MacintoshCopying still pictures on PC If you no longer need the driver Uninstall ≥When Mode Dial is turned to change modesTo disconnect USB cable safely Double clickMode of the Camcorder and reconnect the cable About the SD CardAbout the compatibility of the card Files recorded on a SD CardComputer PV-GS85 only 256Tape Recording Menu Menu listTape Playback Menu Card Recording Menu Card Playback MenuAdvanced O.I.S. -35-GUIDE Lines -35-SHTR Effect PV-GS85 only Basic DATE/TIME -58-PROTECTMenus related to playback Menus related to recordingOther menus Indications Basic indicationsRecording indications Playback indicationsConfirmatory indications Textual indicationsFunctions Conditions which disable Functions that cannot be used simultaneouslyBefore requesting repair Problems and solutions Remaining tape time indication disappears Different sounds are reproduced at the same timePlayback Pictures Playback images are verticalPush the Reset Switch is displayed Card PV-GS85 only Recorded pictures are not clearPhotoshot playback images do not look normal Even if a card is formatted, it cannot be usedWhen the lens is fogged About condensationAbout dirty heads Remove the tape if it is insertedAbout the battery Be sure to detach the battery after useAbout the Camcorder While carrying the Camcorder, do not drop or bump itAbout the cassette About the AC adaptorAbout the card PV-GS85 only Folder structure of the card Periodical check-upsLCD monitor ViewfinderExplanation of terms Automatic white balanceWhite balance Auto focusSpecifications Http//panasonic.co.jp/pavc/global/cs169 Camcorder Accessory System Accessory# DescriptionCamcorder Accessory Order Form For USA Customers VisaRequest for Service Notice Request for Service Notice USA OnlyPanasonic Video Products Customer Services Directory Accessory PurchasesCentralized Factory Service Center Npcparts@us.panasonic.comWarranty For Canadian Customers Ambler Drive, Mississauga, Ontario L4W 2T3Camcorder Product One 1 year, parts and labour For Product Operation ASSISTANCE, please contactIndex NumericsSpanish Quick Use Guide Guía española para el uso rápido Cómo apagar la alimentación Grabación en una cintaGrabación de imágenes fijas en una Reproducción de la cintaLSQT1121 LSQT1121 LSQT1121 Panasonic Puerto Rico, Inc
Related manuals
Manual 81 pages 30.22 Kb
Top Page Image Contents