Panasonic PV-DV52 operating instructions Charge the Battery Pack on the AC Adaptor, Batt Release

Page 11
charge.
• CHARGE Lamp lights up. It goes out when charging is complete (approx. 1 hour). Expect approx. 1 hour
30 minutes of operation (using EVF) when fully charged.
3Remove the Battery.
Slide the Battery out and then lift up.
to
2Attach the Battery as shown
Supplying Power
1Connect and plug in the Power Cord as shown.
• POWER Lamp will light.
• Remove the DC Cable, if attached, from the adaptor.

Charge the Battery Pack on the AC Adaptor

Before Use

POWER Lamp

CHARGE Lamp

Note

About the Flashing of the CHARGE Lamp

Charge the Battery within an ambient temperature range of 10 °C (50 °F) and 30 °C (86 °F).

If charging is done in extreme low or high temperatures, Battery charge time increases.

CHARGE Lamp flashes when...

The Battery is being charged, but charging is taking longer than normal.

Charging is not possible. Remove the Battery once, wait a short time, then re-attach it for charging.

Insert the Battery Pack

 

Remove the Battery Pack

2 1

1 Insert the Battery Pack and slide it up

until it locks with a click.

1

3

2

BATT RELEASE

1 Tilt Viewfinder upward.

2 Remove the Battery Pack and slide the Battery downward while sliding the

BATT RELEASE.

11

Image 11
Contents Operating Instructions PV-DV52 Safety PrecautionsThings You Should Know Above markings are located on the appliance bottom coverImportant Safeguards Important Safeguards Table of Contents Erase Protection Before UsingUnpack your Palmcorder Record Speed/Playback TimeTo remove the cassette Adjust the LengthEasy Cassette Eject/Insertion Attaching the Shoulder StrapHold down Light for more than 0.7 seconds to turn on or OFF Using the Built-in LightHand Strap Lens CapMonitor, and swing it fully open Insert the Battery PackQuick Guide Insert CassetteTo Watch Playback in the LCD Liquid Crystal Display Camera RecordingBatt Release Charge the Battery Pack on the AC AdaptorInsert the Battery Pack Remove the Battery Pack About the Flashing of the Charge LampUse AC Adaptor Supplying PowerBattery Care Push Rotate Setting the ClockSet the Date and Time ExampleVCR Main menu Using the Palmcorder MenuDisplaying the Menu Camera Main menuEVF Camera RecordingSimple Recording Clip hereEVF/LCD Using the LCD MonitorTo adjust the LCD/EVF Brightness or Color 180 Start recordingPhotoshot JOG KEY 1POWER 2MENU Digital PhotoShot ModeProgressive PhotoShot Mode 1POWER 2PHOTOSHOTZoom quickly Set Power to Camera Zoom slowlyZoom Recording Check2STILL JOG KEY 2MENU 5REC Pause 1POWERRecording Still Pictures Self Recording1POWER 3BACK Light Special Effect FeaturesCinema Mode JOG KEY 1POWER 2MENU 5REC/PAUSEProgram AE Fade Out Audio/Video Fade In/OutFade Photoshot KEY 1POWER 2MENU 7REC Pause Camera StillPicture in Picture PinP Main PictureFollowing cases, the indication flashes Advanced SettingsFor manual White Balance adjustment White BalanceMacro Focus for close-ups Auto FocusManual Focus High Speed Shutter JOG KEY 1POWER 2AUTO/MANUALAdjusting the Iris Manually Playback Your Recordings Playback using the LCD MonitorConnecting Earphone not supplied EVF/LCDR Adjusting the VolumeRepeat Playback Blank SearchFast Forward/Rewind Check Rapid Visual SearchStill Picture Jog Frame by Frame Search Special Effect FeatureRotate JOG KEY to adjust Variable Speed SearchSlow Strobe Multi ModeFast NormCable Supplied View Recording/Playback on your TVTV with AUDIO/VIDEO in Jacks OUTZoom In T Digital FeaturesRepeat steps 2~4 to select OFF to cancel this feature Digital ZoomJOG KEY repeatedly to select OFF JOG KEY 2MENU 1POWER 5PLAYMagicPix Images 3REC/PAUSE Bplay Dual Digital Electronic Image Stabilization System D.E.I.SI.S. may not function when To use the MIX function Other Digital FunctionsTo use the Wipe function 12 bit Editing FeaturesAudio Dubbing using the Built-in Microphone Set Power to VCR Press PLAY. Then pressPress Pause to stop Audio Dubbing 7PAUSEMonitor with your TV Copying your Tapes to VHS CassetteInsert a pre-recorded tape into Copying from Digital Equipment dubbingRecording Palmcorder Pause 6STOP 4RECPC Connection with DV Interface Cable i.LINK PC ConnectionConnection Turn on your PC Set the Palmcorder Power to VCRPhotovu Link Driver Optional System Requirements for Photovu Link Driver OptionalRunning the Software Photovu LinkUsing Tape Image Data Palmcorder Accessory System Visa Palmcorder Accessory Order FormHandle bulb gently. Excessive force may cause bulb to crack Replacing the BulbMixture Approximate Brightness ValuesSpecifications Lens Hood Area Operation Caution Before Requesting ServiceCleaning Care for Video Heads Tape Operations CautionSymptom Correction Request for Service NoticeFor On-Screen Displays OSDLimited Warranty Limited WarrantyAccessory Purchases Customer Services DirectoryAdvertencia del FCC Precauciones para su seguridadFilm de protección Inserte de la bateríaInserte el Cassette Automáticamente Grabación con la cámaraCuando el monitor LCD se enchuentra Totalmente abierto, el visor se DesactivaIndex Camera Mode Menu ScreenBeep VCR Mode Menu Screen 10 11 10 C.RESET p13 LCD/EVF Setting p Important Note CAMERA/VCR Mode Rear View Index of ControlsFront View Side ViewBack View Top ViewUnderside View AC Adaptor Power Lamp Charge LampTripod Receptacle AC Power Cord pp VCR DC Output Connector Photovu Link IndexMenu OSD

PV-DV52 specifications

The Panasonic PV-DV52 was a compact and versatile camcorder that left an impression in the world of digital video recording during its time. Renowned for its user-friendly design and advanced features, the PV-DV52 catered to both amateur filmmakers and seasoned videographers seeking portability and quality.

One of the primary highlights of the PV-DV52 is its recording capability. This camcorder featured a MiniDV format, allowing users to record high-quality digital video with exceptional clarity. The MiniDV format ensured that the footage produced was crisp and vibrant, making it ideal for capturing special moments or creating home movies.

The PV-DV52 was equipped with a 3CCD imaging system, a notable technology that set it apart from many competitors. Unlike standard camcorders that use a single CCD, the 3CCD system utilized three separate CCD sensors—one for each primary color (red, green, and blue). This design resulted in improved color accuracy, enhanced image detail, and reduced artifacts, producing stunning visuals that truly represented the scene.

Another impressive feature of the PV-DV52 was its optical zoom capabilities. The camcorder came with a 10x optical zoom lens that enabled users to capture distant subjects without compromising quality. Additionally, users could employ a digital zoom feature, further extending their reach when needed. This flexibility made the camcorder ideal for various shooting scenarios, from capturing wildlife at a distance to recording events in large venues.

The PV-DV52 also prioritized ease of use, equipped with a user-friendly interface and intuitive controls. A flip-out LCD screen provided users with the ability to monitor their recordings easily, making framing shots and reviewing footage straightforward. The camcorder had built-in stabilization technology, which minimized the impact of shaky hands while filming, resulting in smoother video playback.

Moreover, the Panasonic PV-DV52 offered a range of connectivity options, including FireWire (IEEE 1394) ports, facilitating easy transfer of video to computers for editing. This feature was particularly significant, as it allowed for a seamless workflow for aspiring filmmakers looking to enhance their content.

Overall, the Panasonic PV-DV52 was a well-rounded and dependable camcorder that leveraged advanced technologies to deliver professional-quality video recording in a compact package. Its combination of 3CCD imaging, optical zoom, and user-friendly features made it a popular choice during its era, appealing to various users seeking to capture life's important moments with ease.