Kenwood KDC-7024, KDC-M7024 Button Adjustment Item Display Range Non-Fading, 50/80/120/Through Hz

[3] button
	Adjustment Item	Display	Range
	Middle Center	"MID F"	0.5/1.0/1.5/2.0 kHz
	Frequency
	Middle level	"Middle"	–8 — +8
	Middle Q Factor	"Middle Q"	1.0/2.0
[4] button
	Adjustment Item	Display	Range
	Treble Center	"TRE F"	10.0/12.5/15.0/17.5 kHz
	Frequency
	Treble level	"Treble"	–8 — +8
[5] button
	Adjustment Item	Display	Range
	Balance	"Balance"	Left 15 — Right 15
	Fader	"Fader"	Rear 15 — Front 15

• According to the Bass Q Factor setting value, the frequencies that can be set in Bass Center Frequency change as shown below.

Bass Q Factor	Bass Center Frequency
1.00/1.25/1.50	60/70/80/100
2.00	60/70/80/150

•When the bass extend is set to ON, low frequency response is extended by 20%.

[3] button
	Adjustment Item	Display	Range
	Non-Fading	"LPF NF"	50/80/120/Through Hz
	Low Pass Filter
[4] button
	Adjustment Item	Display	Range
	Loudness	"LOUD"	ON/OFF
[5] button
	Adjustment Item	Display	Range
	Non-Fading level	"NF Level"	–15 — +15

• Loudness: Compensating for low and high tones during low volume.

•When the Dual Zone System is ON, the setting for the High Pass Filter is nullified.

3rd section
[2] button
Adjustment Item	Display	Range
Volume offset	"V-Offset"	–8 — ±0

Volume offset: Each source's volume can be set as a difference from the basic volume.

2nd section
[2] button
Adjustment Item	Display	Range
Front/Rear	"HPF"	Through/100/125/170 Hz
High Pass Filter

— 13 —