![](/images/new-backgrounds/1248990/24899049x1.webp)
Setup 3 Inserting/Removing SD
cards (sold separately)
SD cards are sold separately. Preparations: Set the mode dial to [OFF].
(Check that the status indicator is out.)
Inserting or removing an SD card with the power ON may damage the unit and destroy data on the card.
1 Opendoor. the card/battery
Lift the flap upright and turn it
2 Insert/Removecard. the SD
•To insert:
Face the label upwards and slide the card in straight until hearing it catch.
•To remove:
Press the center of the SD card and pull the card out straight.
3 door.Close the card/battery | Place label upwards. |
|
•Close the door and turn the flap clockwise to the locking position and then push the flap back flat. •If the door does not close completely, remove the SD card, check its orientation and reinsert it into the slot.
●While the card access lamp is lit, reading, recording, playback, deletion or other processing is being executed. Performing the following operations while the lamp is lit may damage the SD card and its content and the unit may not function properly.
•Switching off power
• Removing battery or AC adaptor
• Opening card/battery door and removing SD card
• Rotating the mode dial
• Shaking or impacting the unit
• Disconnecting the USB cable
●The access lamp is supposed to light up while rotating the dial to select a mode. In this case, there is no problem.
VQT2A17 25