Controls and their functions
Lens mount (Bayonet type)
This is where the lens is mounted.
Lens clamp lever
The lens is inserted into the lens mount , and this lever is then turned to clamp the lens in place.
Lens cable, mic cable clamps
These are used to clamp the lens cable and mic cable in place.
DCamera hangers (supplied)
When the buildup unit
For details, refer to the Operating Instructions for AK‑HBU3500.
ETripod mount
Before securing the
FShoulder pad
This is used when the
GSlide lock release lever
This is held down while it is used to adjust the front/back position of the shoulder pad F.
HShoulder strap fitting
This enables the shoulder belt to be attached.
IOptical cable clamp
This enables the optical cable to be clamped.
JCamera No. plate holder
This enables the accessory camera No. plate to be attached.
KOptical fiber connector (EDW.3K made by LEMO)
Camera power switch [POWER]
This is used to select the camera power input (power supplied from the CCU or from an external connector) and turn the power ON and OFF.
Power LED
This lights up green when power is supplied to the camera.
When the camera’s power switch is set to OFF, this lights up red if the CCU is connected, and it goes off if the CCU is not connected.
Power circuit breaker [BREAKER]
This shuts off the power in the event of an overcurrent while the DC 12 V power supply is used.
To reset it, press the circuit breaker button.
INCOM connectors 1, 2 [INCOM1, INCOM2]
The INCOM or headset plugs are connected here.
INCOM1 MIC ON/OFF switch [MIC1 TALK]
This is the INCOM1 MIC ON/OFF selector switch.
INCOM1 level control [INCOM1 LEVEL]
This is used to adjust the INCOM1 receive level.
INCOM2 MIC ON/OFF switch [MIC2 TALK]
This is the INCOM2 MIC ON/OFF selector switch.
INCOM2 level control [INCOM2 LEVEL]
This is used to adjust the INCOM2 receive level.
9INCOM1 PGM1 level control [INCOM1 PGM1]
This is used to adjust the INCOM1 and PGM1 mixing level.
INCOM1 PGM2 level control [INCOM1 PGM2]
This is used to adjust the INCOM1 and PGM2 mixing level.
INCOM2 PGM1 level control [INCOM2 PGM1]
This is used to adjust the INCOM2 and PGM1 mixing level.
INCOM2 PGM2 level control [INCOM2 PGM2]
This is used to adjust the INCOM2 and PGM2 mixing level.
This switch is used to select the return images to be switched by
This switch is used to select the return images to be switched by
CALL LED
This lights up green when the CALL switch is pressed. It also lights in response to a call from the ROP or MSU.
CALL switch [CALL]
This lights the CALL LED on the ROP or MSU and sounds the buzzer.
OPT LED
This indicates the camera’s optical signal reception status. It normally lights up green. When any problem has occurred, it lights up red.
When a problem has occurred, clean the optical fiber connector.