Panasonic WV-NP244 operating instructions Rear

Page 11

<REAR>

q w

e

r

MONITOR OUT

INITIAL SET

EXT I/O	SD
1 2 3 4	CARD

LINK

POWER

10BASE-T/ 100BASE-TX ACT

u

i o

t

GND

AC 24V IN : 1L – 2N

DC 12V IN : ! – @

y

!0

qPower indicator (green)

wLink indicator

eMonitor out connector (for adjustment) (ø3.5 mm, mini jack)

rINITIAL SET button

tExternal I/O terminals

yGround terminal

uAccess indicator

iNetwork connector

oSD memory error indicator (red)

!0AC 24 V/DC 12 V

Power cable terminals

•About the [INITIAL SET] button

Turn on the power of the camera while holding down this button, and wait around 5 sec- onds without releasing this button.

Wait around 30 seconds after releasing the button. The settings including the network set- tings will be initialized.

11

Image 11

Contents Operating Instructions Do not Remove Cover or Back No USER-SERVICEABLE Parts Inside Important Safety Instructions Tion of the Product Disclaimer of WarrantyLimitation of Liability Preface FeaturesCPU About these Operating InstructionsSystem Requirements for a PC Trademarks and Registered TrademarksContents Precautions Radio disturbance PoE Power over EthernetBroadband router Major Operating Controls and Their Functions Rear Lens type Model number Focus adjustmentLens Mounting Optional lensHow to use a vari-focal lens How to use a fixed-focal lensExample Installations/ConnectionsStep AUX OUT Specification of cable wireAlarm OUT RatingsRequired hardware Connection exampleRequired cable Insert/Remove an SD Memory Card How to insert an SD memory cardHow to remove the SD memory card Software included on the provided CD-ROM Performing the Network SettingsInstall the software Start the Panasonic IP Setting software When using a PoE device for power supply TroubleshootingWhen using AC/DC power supply Network SpecificationsOther specifications CameraMain functions TCP/IP, UDP/IP, HTTP, RTP, FTP, SMTP, DHCP, DNS, DdnsNTP, Snmp CD-ROM Standard AccessoriesPanasonic Canada Inc