axis international marketing 2110 manual Installing Your Camera via a Modem

AXIS 2110 Installation Guide - English Page 2 of 5

Verifying and Completing the Installation From Your Browser

To access the AXIS 2110 Home Page, start your browser and enter the IP address in the location/ address field, e.g. 171.21.1.200.

Click the Installation Wizard link. The wizard guides you through the remaining installation procedures and will help you configure your application. Detailed information on how to use the

various product functions is conveniently provided in the on-line help, available from the configuration pages.

Installing Your Camera via a Modem

The information in this section describes how to connect the AXIS 2110 to a serial modem for transmitting images over a normal Dial-Up connection.

Important!

•The information and screen examples featured here are specific to Windows NT. Although similar to the Dial-Up implementations in Windows 95, 98, and 2000, small deviations in the dialog instruc- tions for other operating systems should be expected. Refer to your system information for further information on creating a Dial-Up modem connection if you are using any other operating system.

•Windows Dial-Up Networking and TCP/IP must be correctly installed prior to commencing with the modem cable connection. Detailed information on how to check this is provided in Windows Help.

Connecting Your Computer Using the Null Modem Cable

Follow the steps below to configure a serial modem connection for your AXIS 2110:

Connect the supplied Null modem cable
between the COM1 Serial Connector on the
									￿From the Start menu, open the Con-
AXIS 2110 and the COM port of your computer.
									trol Panel and click the Modems icon.
	Connect the power supply to the
AXIS 2110 and check that the Power							If a Standard Modem is already set up and
Indicator is lit.						displayed in the Modem Properties dialog (see
						right) you should proceed directly to step 8.
￿
				Check the checkbox: Don’t detect
				my modem, I will select it from a list.
				Click Next>.
￿
						Select the Standard 28800
					modem from the displayed list of
					modems.￿				Click Next>.
				￿
											Select the serial port to which your
											AXIS 2110 is now connected via the
											Null Modem cable. Click Next>.
			A Standard 28800 modem connection is
			now available for the AXIS 2110. Click Finish								Click the Properties button to finally check that the dis-
			to close the Install New Modem wizard.
										played Communications Port is set correctly; that is, set to
					￿
										the same port you connected the AXIS 2110 to. Click OK.
		￿								￿￿
								Click Close.