axis international marketing 2110 manual Reinstating the Factory Default Settings

Page 6
indoor scene - fully open (O) outdoor scene - mid position (between C and O)

AXIS 2110 Installation Guide - English

Page 5 of 5

Reinstating the Factory Default Settings

In certain circumstances, it may be necessary to reinstate the Factory Default settings for your AXIS 2110. This is performed by clicking the appropriate button within the Administration Tools, or by pressing the Control Button. Follow the instructions below to reinstate the product factory default settings using the Control button:

1.Switch off the AXIS 2110 by disconnecting the power cable.

2.Press and hold the Control Button depressed, and reconnect the power supply cable.

3.Continue to keep the Control Button pressed until the Status Indicator displays yellow (note that this may take up to 15 seconds), then release the Control Button. When the Status Indicator displays green (which can take up to 1 minute) the AXIS 2110 will then have been reset to the original factory default settings.

Note: Reinstating the original default settings causes all parameters (including the IP address) to be reset.

Mounting and Focusing Your Camera

The AXIS 2110 can be mounted on the supplied mounting assembly, or installed into a weatherproof enclosure for use in outdoor applications. For further information on outdoor enclosures, follow the camera accessory links at the Axis website at www.axis.com

Having mounted the AXIS 2110, focus the camera following the instructions below:

Important!

Although the AXIS 2110 is intended for indoor and outdoor use, it is important to note that the charged coupled device (CCD) in the camera can become permanently damaged if it is exposed to too much direct sunlight, or halo- gen light. Therefore, it is important that the Iris Adjustment Ring is not set fully open when installing the camera in bright light conditions. The Axis warranty does not cover CCD damage caused by prolonged exposure to strong light.

Tip! When mounting the camera behind glass, make sure that the camera lens is not too far away from the glass - particularly when installing the unit in an outdoor enclosure. This will help reduce undesirable reflection within the image.

Power-on the AXIS 2110 and wait 10 seconds.

￿The Iris Adjustment Ring effectively closes and ￿opens the camera lens to regulate the amount of light entering the camera. Closing the ring reduces the amount of light; this protects the CCD and gives a better depth of field, i.e. focus over a greater distance. A more open lens provides better results in low-light conditions.

Rotate the Iris Adjustment Ring to an appropriate position for your chosen installation, as follows:

Iris Adjustment Ring

Tele/Wide Zoom Ring

Focus Ring

Status Indicator

Control Button

Start your browser applica- ￿tion and check the picture. Adjust the Tele/Wide Zoom Ring to a suitable postion for your application.

Rotate the Focus Ring to an ￿appropriate positon - until you are satisfied with the focus of the camera image.

Image 6
Contents Axis Network Camera Arp -s IP address Ethernet address temp Installing Your Camera on a NetworkThese commands Line Syntax Ping -t Server IP address Ping IP addressInstalling Your Camera via a Modem Verifying and Completing the Installation From Your BrowserConnecting Your Computer Using the Null Modem Cable Configure Creating a Dial-Up Networking ConnectionRefining the Dial-Up Networking Properties Initiating the Dial-Up ConnectionVerifying the Modem Connection Reinstating the Factory Default Settings Mounting and Focusing Your CameraPower-on the Axis 2110 and wait 10 seconds