LTC 9384 Series Instruction Manual Installation | EN 13 |
|
|
Front Face
Breather Hole
Front Endcap
| Rear Face of Head Should |
Grip and Pull | Be Flush with Front Face |
of Front Endcap |
FIGURE 12 Breather Hole
Proper installation of the pull seal is as follows:
1.Remove the cradle assembly from the housing.
2.Obtain a rubber pull seal (Part Number
315 2569 001) from the hardware kit (see FIGURE 13). An extra pull seal is also provided.
Head 
Long End
FIGURE 13 Pull Seal
3.Insert the long end of the pull seal into the breather hole starting from the front of the endcap (see FIGURE 14).
FIGURE 15 Installing the Pull Seal
5.9.2Cradle Assembly
1.Position the housing vertically and replace the cradle assembly by applying pressure onto the rear cap until the end of the cradle is approximately flush with the back of the housing (see FIGURE 16).
Cradle
Front of
Endcap
Pull Seal
FIGURE 16 Inserting the Cradle Assembly
Breather Hole
FIGURE 14 Inserting the Pull Seal
4.Grip the pull seal's long end from the back of the front endcap. Steadily pull the long end until the head of the pull seal is flat against the front of the endcap (see FIGURE 15).
NOTE: The pull seal's long end will stretch when pulled through the breather hole.
CAUTION: If a pull seal is installed in the breather hole, be careful not to pinch the head of the pull seal. Damage to the pull seal may allow water to enter the housing, causing damage to the camera and lens.
2.Tighten the retention screw, making sure it is seated into the rear cap groove. If the housing needs to be
3.Attach the housing to the appropriate mount or pan/tilt per the instructions provided. According to the orientation of the housing, the cradle assembly may need to be rotated. To rotate the cradle assembly (while mounted), grasp the rear handle and rotate it to the desired position. View the monitor while rotating.