Using the Radio Data System (RDS) (continued)
■Notes for RDS operation
If any of the following events occur, it does not mean that the unit is faulty:
●“PS”, “NO PS” and a station name appear alternately, and the unit does not operate properly.
●If a particular station is not broadcasting properly or a station is conducting tests, the RDS reception function may not work properly.
●When you receive an RDS station whose signal is too weak, information like the station name may not be displayed.
●“NO PS”, “NO PTY” or “NO RT” will be displayed for few seconds, and then the frequency will be displayed.
Notes for radio text:
●The first 8 characters of the radio text will appear for 4 seconds and then they will scroll across the display.
●If you tune in to an RDS station which is not broadcasting any radio text, “NO RT” will be displayed when you switch to the radio text position.
●Whilst radio text data is received or when the text contents change, “RT” will be displayed.
■To recall stations in memory
To specify programmed types and select stations (PTY search):
You can search a station by specifying the programme type (news, sports, traffic programme, etc.) from the stations in memory.
1Press the FUNCTION button repeatly to select TUNER function.
2Press the RDS PTY button on the remote control.
Selected PTY code (blinking) will appear for about 6 seconds.
3Within 6 seconds, press the 
or 
button to select the PTY code.
Each time the button is pressed, the PTY code will appear.
4Whilst the selected PTY code is displayed (within 6 seconds), press the RDS PTY button again.
●The unit searches the all preset stations and stops when it finds a station of the selected category then tunes into the stations. The RDS indicator lights up.
●If no programme is found in the all preset stations, “NO PTY” appear on the display and returns to the previous station.
Using the Radio Data System (RDS) (continued)
Notes:
●If the display has stopped flashing, start again from step 2. If the unit finds a desired programme type, the corresponding channel number will lit for about 4 seconds, and then the station name will remain lit.
●If you want to listen to the same programme type of another station, press the RDS PTY button and start again from step 2. The unit will look for the next station.
Setting the clock (Remote control only)
In this example, the clock is set for the
1Press the
2Press and hold the (TIMER)/CLOCK button until “00:00” appear.
3Within 10 seconds, press the 
or 
button to adjust the hour and then press the MEMORY button.
Press the 
or 
button once to advance the time by 1 hour. Hold it down to advance continuously.
4Press the 
or 
button to adjust the minutes and
then press the MEMORY button. Press the 
or 
button once to advance the time by 1 minute. Hold it down to advance continuously.
To confirm the time display:
[When the unit is in the
Press the (TIMER)/CLOCK button. The time display will appear for about 5 seconds.
[When the power is on]
Press the (TIMER)/CLOCK button. The time display will appear for about 5 seconds.
Note:
The “00:00” will appear when the AC power supply is restored after a power failure or unplugging the unit. Readjust the clock as follows.
To readjust the clock:
Perform “Setting the clock” from step 1.