4.COLOR OVERVIEW CAMERA LENS SETTING
The following steps show the installer how to access the camera board and the camera lens.
Step 4.1 - Remove sunshield by loosening top bolt with a standard Philips screwdriver.
Step 4.2 - Disconnect the power source to the camera and the video signal at the BNC connector.
Step 4.3 - Remove the four cap screws with a 3mm Allen key. See Figure
Step 4.4 - Carefully slide out the rear housing from the main enclosure. Make sure the gasket remains with the rear section.
See Figure
Step 4.6 - Carefully slide the rear section into the main enclosure and tighten the cap screws.
- 10 -