Panasonic WV-NW484S operating instructions Enlarged view of a

Page 24

Installing the Camera (continued)

6Adjust the camera angle while monitoring the image on the adjustment monitor.

See "Adjusting the Camera" on page 28.

75°

Tilt adjustment

seat

Monitor output connector (mini-jack)

7Install the enclosure.

Tighten the screws unscrewed at step 3 using the driver bit (provided). Align the mark on the side of the enclosure with the line on the side of the bracket. (recommended torque: 0.78 N·m {8 kgf·cm})

Line on the side

Panning table

Tilt lock screw

Pan lock screw

A

Marking on the side

Installation bracket

Enclosure

Enlarged view of A

Note.........................................................................................................................

When installing the enclosure, the camera focus may shift slightly out of position. So, either hold the ABF button down for at least two seconds before installing the dome

cover, or make the final adjustment on the PC after installing the dome cover. (page 28)

When installing an SD memory card, insert the card before installing the enclosure.

(page 32)

.............................................................................................................................

24

Image 24
Contents Operating Instructions Accompanying the appliance Important Safety Instructions Disclaimer of Warranty Limitation of LiabilityFeatures PrefaceAbout these operating instructions System requirements for a PCPreface Trademarks and Registered Trademarks Network SecurityContents Action at an alarm occurrence Troubleshooting SpecificationsPrecaution MPEG-4 Visual patent portfolio license SD Memory Card CCD Color Filter Burn-inPrecaution Do not point the camera at a strong light SourceConsumables Dehumidifying ElementNames of Components Names of Components Functions Super Dynamic III SUPER-DMotion Detector Privacy Zone Setting Progressive outputAuto Back Focus Function Recording to an SD Memory CardPower over Ethernet EnvironmentsInstallation and Connections Installation PrecautionsPower Supply by PoE About Static Electricity RemovalNetwork Connection Tightening the ScrewsBefore Starting Installation Fixing the bracket accessoryInstalling the Camera Installing the Camera Install the camera on the mounting Enlarged view of a Connecting the Cables Power cable Brown LiveBlue Neutral Green/yellow GNDConnecting the Cables Waterproofing Cable JointsBottom side Water drain groove Adjusting the Camera Adjust the focus Adjusting the Camera How to Change the View AngleHow to Focus capturing subjects with a self-closing lens How to Use the Varifocal Lens and Zoom LensAlarm In/Out Ratings Pin Arrangement of 4-pin Alarm Cable accessoryHandling SD Memory Cards Insertion and Removal of SD Memory CardsHow to Install the Heater Unit Heater UnitConnection Examples Direct connection to a PCNetwork connection via a PoE-compatible hub Network Setup Installing the SoftwareUsing the Panasonic IP Setup Software to Set Up the Camera Software in CD-ROMNetwork Setup Monitor Images on a PC Monitor Images on a PC ZoomMenu. → Setup Manual Monitor images from a single camera Web browser screenLive Monitor images from multiple cameras Multi-screen window Action at an alarm occurrence Alarm typeAction at an alarm occurrence Action at an alarm occurrence Setup screen Viewing HelpDisplaying the Help screen Help screenTroubleshooting AC/DC power supplyPoE power supply Camera does not Turn onSpecifications AGC HIGH, F1.4, WideSpecifications LOW/HIGHAccessories Panasonic System Solutions Company Panasonic Canada Inc