Panasonic WV-NW484S operating instructions Adjusting the Camera

Adjusting the Camera

1 Adjust the camera angle while

monitoring the image on the

adjustment monitor.

Connect the adjustment monitor

(small LCD monitor, etc.) to the

monitor output terminal, and adjust

the camera angle.

Determine and set the camera angle

while repeating the fine-adjustments

in steps (1), (2) and (3) below.

75°

(3) Tilt adjustment seat

Panning table

Monitor output connector (mini-jack)

(2) Tilt lock screw

(1)	Loosen the pan lock screw, and
	rotate the camera horizontally to
	adjust pan.
(2)	Loosen the 2 tilt lock screws, and
	rotate the camera vertically to
	adjust tilt.
(3)	Turn the tilt adjustment seat to
	adjust the screen tilt.
(4)	When the camera angle is
	determined, tighten the pan lock
	screw and the tilt lock screws.

(1) Pan lock screw

Note..............................................................................................................................

•Also adjust the focus in step 2 during pan and tilt adjustment.

...................................................................................................................................

Important

• Be sure to tighten the panning lock screw (recommended torque: 0.59N·m {6 kgf·cm}).

28