Axis Communications 231D+/232D+ user manual PTZ controls, Click-in-image, Focus and Iris Controls

26AXIS 231D+/232D+ - Live View Config

PTZ controls

•the Pan bar - moves the camera to the right and left

•the Tilt bar - tips the camera up and down

•the Zoom bar - zooms the view in and out

•the Focus bar - adjusts the focus

•the Iris bar - adjusts the brightness of the image

Clicking on the bars themselves or on the arrows at the end of the bars will move the camera to a new position.

Each position on the bar (see right) represents a defined position in the camera’s range of movement,

with the center of the bar representing the point midway between the two extremes of movement.

Clicking a position directly on the bar moves the camera directly to the new position in one smooth movement. Clicking on the arrows at the ends of a bar causes a stepped, incremental change.

Click-in-image

The PTZ device can also be controlled using click-in-imagemovement, which can also be of relative or absolute type.

Absolute click-in-image movement means that the camera view will center on the absolute position that was clicked.

Relative click-in-image movement means that by clicking and holding the mouse button down in the image, the PTZ device moves the camera in that direction, relative to the center of the image. The further from the center the image is clicked, the greater the movement.

You can also use Area Zoom to draw a box over a desired area to zoom in on. Using your mouse click in the image where you want the center of the area you are are going to zoom in on, and while holding down the left mouse button draw a square over the size of area you would like to zoom in on.

Focus and Iris Controls

The Focus and Iris (image brightness) can be adjusted manually by using the control bars, or they can be set for automatic adjustment, by clicking the Auto Iris and Auto Focus buttons.