Page 14 | AXIS 209FD/AXIS |
LED indicators
LED | Color | Indication |
|
|
|
Network | Green | Steady for connection to a 100 Mbit/s network. Flashes for network activity. |
|
|
|
| Amber | Steady for connection to 10 Mbit/s network. Flashes for network activity. |
|
|
|
| Unlit | No network connection. |
|
|
|
Status | Green | Steady green for normal operation. |
|
| Note: The Status LED can be configured to be unlit during normal operation, or to |
|
| flash only when the camera is accessed. To configure, go to Setup > System |
|
| Options > LED settings. See the online help files for more information. |
|
|
|
| Amber | Steady during startup, during reset to factory default or when restoring settings. |
|
|
|
| Red | Slow flash for failed upgrade. |
|
|
|
Power | Green | Normal operation. |
|
|
|
| Amber | Flashes green/amber during firmware upgrade. |
|
|
|
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1.Disconnect the network cable from the camera.
2.Using the supplied allen/hex key, loosen the 4 screws holding the cover and remove it.
3.Press and hold the Control button and reconnect the network cable.
4.Keep the Control button pressed until the Status indicator displays amber (this may take up to 15 seconds).
5.Release the Control button. When the Status indicator displays green (which can take up to 1 minute) the process is complete and the camera has been reset.
6.
It is also possible to reset parameters to the original factory default settings via the web interface. For more information, please see the online help or the user’s manual.
Further information
The user’s manual is available from the Axis Web site at www.axis.com or from the Axis Network Video Product CD supplied with this product.
Tip!
Visit www.axis.com/techsup to check if there is updated firmware available for your AXIS