Axis Communications 209FD/FD-R manual Install the hardware, Mount the camera

AXIS 209FD/AXIS 209FD-R Installation Guide Page 5

Install the hardware

!IMPORTANT! - The casing of the AXIS 209FD is not approved for outdoor use and may only be installed in indoor environments.

The AXIS 209FD-R is ruggedized and can be used in damp environments.

Mount the camera

The AXIS 209FD/AXIS 209FD-R can be mounted with the cable routed through the ceiling or from the side.

The AXIS 209FD is supplied with a standard RJ-45 female network connector, on a 2 meter cable.

The AXIS 209FD-R is supplied with a 29mm female RJ-45 network connector on a 0.5 meter cable. To protect the cabling against moisture this connecter must be connected to a suitable 29mm male connector.

1.Using the supplied allen/hex key, loosen the 4 screws holding the cover and remove it.

2.Use the base plate to mark out the positions for the mounting screws.

3.To route the cable through a ceiling or wall, cut or drill the hole for the cable and connector.

For the AXIS 209FD - cut a 17mm hole.

For the AXIS 209FD-R - cut a 30mm hole.

-or-

For a surface mounted cable, cut out the cable exit hole at the rear of the cover

ENGLISH