6.Click [OK].
Manual network setup will be completed.
7.When the manual setup including <IP> is completed, the camera will restart.
If the IP router has more than one camera connected
Configure the IP related settings and the Port related settings distinctly with each other.
Category | Camera #1 | Camera #2 | |
|
|
|
|
| IP Address | 192.168.1.200 | 192.168.1.201 |
IP related settings | Subnet Mask | 255.255.255.0 | 255.255.255.0 |
| Gateway | 192.168.1.1 | 192.168.1.1 |
|
|
|
|
| HTTP Port | 80 | 10000 |
| Device Port | 60001 | 10001 |
Port related settings | TCP Port | 60002 | 10002 |
| UDP Port | 60003 | 10003 |
| Upload Port | 60004 | 10004 |
| Multicast Port | 60005 | 10005 |
|
|
|
|
M If the <HTTP Port> is set other than 80, you must provide the <PORT> number in the address bar of the Internet browser before you can access the camera.
ex) http://IP address : HTTP Port http://192.168.1.201:10000
Auto Network Setup
Run <IP Installer.exe> to display the camera search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
M For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not support this function.
1.Select a camera in the search list.
Find the MAC (Ethernet) address labeled on the rear of the camera.
Both the [Auto Set] and [Manual Set] buttons will be activated.
2.Click [Auto Set].
The AUTO SET dialog appears.
The <IP Address>, <Subnet Mask>, and <Gateway> will be set automatically.
