Installing the PIX 535 DC Model

Chapter 7 PIX 535

Note You must use a GE failover link when connecting the PIX 535 with GE interfaces.

The Gigabit Ethernet circuit board and the fiber optic cable connection are shown in Figure 7-15.

Figure 7-15 Gigabit Ethernet Circuit Board

TX RX LINK

33010

The Gigabit Ethernet circuit board has three LEDs:

•TX—Transmitting data

•RX—Receiving data

•LINK—The Gigabit Ethernet circuit board has established a network connection

Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit. To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit breaker in the OFF position.

To install the PIX 535 DC power model, perform the following steps:

Step 1 Remove the blank cover plate, if a blank cover plate is installed on the PIX 535.

Step 2 Read the Regulatory Compliance and Safety Information document for your respective software version.

Cisco PIX Security Appliance Hardware Installation Guide

	78-15170-03	7-21