Cisco Systems user service PIX Installing the PIX 535 DC Model

Page 23

Chapter 7 PIX 535

Installing the PIX 535 DC Model

Step 9 Reconnect power to the PIX 535. After wiring the DC power supply, remove the tape from the circuit breaker switch handle and reinstate power by moving the handle of the circuit breaker to the ON position.

Step 10 If needed, install the interface boards as described in the “Installing a Circuit Board in the PIX 535” section on page 7-14.

Step 11 Power on the unit from the switch at the rear of the unit.

Note If you need to power cycle the DC PIX 535, wait at least 5 seconds between powering off the unit and powering it back on.

Your unit is now ready to configure. Refer to the configuration guide online at:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/prod_configuration_guides_list.html.

Cisco PIX Security Appliance Hardware Installation Guide

 

78-15170-03

7-23

 

 

 

Image 23
Contents PIX 535 Product Overview PIX1shows the front view of the PIX LEDs State Description PIX 535 Network Interface Description Mounting the PIX Installing the PIXBefore Installing the PIX PIX 535 Network Interface Installation PIX 535 Feature LicensesVPN Accelerator Card+ VPN Accelerator CardPIX 535 Failover Cable Connection Installing FailoverInstalling LAN-Based Failover LAN-Based Failover Connections Replacing a Lithium BatteryInstalling a Memory Upgrade System Memory Location on the PIX 535 Component Tray Inserting a Dimm Memory Strip in the PIX PIX 535 Circuit Board Options Installing a Circuit Board in the PIXRestricted Interface Options Unrestricted Interface Options 10 PIX 535 Back Panel Detail Circuit Board Slot Description11 The Component Tray at the Back of the PIX Installing a Circuit Board12 4-Port Circuit Board Overlap MB Flash Circuit Board13 16 MB Flash Circuit Board Gigabit Ethernet Circuit Board VPN Accelerator Circuit Board15 Gigabit Ethernet Circuit Board Installing the PIX 535 DC Model16 Attaching a Grounding Lug to the PIX 535 DC PIX Installing the PIX 535 DC Model