Chapter 2 Camera Installation
Installing the IP Camera with a Vandal Resistant Enclosure
Step 5 Perform the following steps to install and connect an RJ45 Ethernet cable.
Note We recommended using 24AWG (0.51 mm) gauge cable.
a.Drill a hole on the rubber seal plug and insert an Ethernet cable (without a connector) through the opening.
b.Strip about 1/2 inch (12 mm) of the sheath from the Ethernet cable.
c.Use an RJ45 crimping tool to attach the Ethernet wires to a connector. When done, connect the cable to the camera’s Ethernet RJ45 socket.
o: white/orange stripe |
|
|
|
| |
o | 1 | ||||
O: orange solid | |||||
g: white/green stripe | O |
|
| 2 | |
g | 3 | ||||
B: blue solid | |||||
B |
|
| 4 | ||
|
| ||||
b: white/blue stripe |
|
| |||
b | 5 | ||||
G: green solid | G |
|
| 6 | |
| |||||
br: white/brown stripe | br | 7 | |||
BR: brown solid | BR |
|
| 8 | |
| |||||
| |||||
Cisco Video Surveillance 7030 IP Camera Installation Guide
|
| ||
|
|