How to use OSD Menu
• Display | [ON/OFF] |
Sets if camera makes mask shows or not on images.
• Clear Mask | [CANCEL/OK] |
Deletes data in the selected mask NO.
❖Privacy Zone Area Setup
EDIT MASK 1
MOVE TO TARGET POSITION [NEAR:SELECT/FAR:CANCEL]
0/0/x1/N
Move camera to area to mask. Then the menu to adjust mask size will be displayed.
If the tilt angle is located in the range between 90° to 90°, you can not set up privacy zone mask.
If tilt angle over 90° (image fl ipped region) is designated, camera will automatically move to identical poison by changing tilt angle less than 90° and moving pan angle 180 relatively.
❖Privacy Zone Size Adjustment
EDIT MASK 1
[ZOOM : COLOR CHANGE] [◄►:ADJUST MASK WIDTH] [▲▼:ADJUST MASK HEIGHT] [NEAR:SAVE / FAR:CANCEL]
Adjust mask size. Use joystick or arrow buttons to adjust mask size.
• ◄► (Left/Right) | Adjusts mask width. |
• ▲▼ (Up/Down) | Adjusts mask height. |
• Zoom In/Out | Change Color of mask. |
To hide a certain zone completely regardless of high speed PT motions, it is recommended that the size of mask must be 20% bigger than original target size.
It is noted that during PAN/TILT control like jog action, the object behind the privacy mask can be disclosed in a short period of time.
MOTION SETUP
MOTION SETUP |
|
PRESET LOCK | OFF |
PWR UP ACTION | ON |
AUTO FLIP | ON |
JOG MAX SPEED | 140/SEC |
JOG DIRECTION | INVERSE |
FRZ IN PRESET | OFF |
<PARKING ACTION SETUP> <ALARM INPUT SETUP>
BACK
EXIT
Setup the general functions of Pan/Tilt motions.
• Preset Lock | [ON/OFF] |
If Preset Lock is set to ON, it is impossible to set up and delete Preset, APAN, Pattern and SCAN. It is possible only to run those functions. To set up and delete those functions, enter into OSD menu.
• Power Up Action [ON/OFF]
Refer to “Other Functions”(page 17) section.
• Auto Flip | [ON/OFF] |
Refer to “Other Functions”(page 17) section.
• Jog Max Speed | [2°/sec ~200°/sec] |
Sets maximum jog speed. Jog speed is inversely proportional to ratio of zoom. As zoom magnifi cation goes up, pan/tilt speed goes down.
• Jog Direction | [INVERSE/NORMAL] |
If you set this to ‘Normal’, the view in the screen is moving same direction with jog tilting. If ‘Inverse’ is selected, the view in the screen is moving reversely.
• Freeze in Preset | [ON/OFF] |
At start point of preset movement, camera starts freezing the image of start point. Camera keeps displaying the image of start point during preset movement and does not display the images which camera gets during preset movement. As soon as camera stops at preset end point, camera starts displaying live images which it gets at preset end point.
20 – 36x SMART DOME CAMERA