FCC Statement

Safety Precautions

6.Do not place conductive objects (e.g., screwdrivers, coins, and metal things) or containers filled with water on top of the camera.

(Serious injury may result from fire, electrical shock, or falling objects.)

7.Do not install the unit in humid, dusty, or sooty locations. (Doing so may cause fire or electrical shock.)

8.If any unusual smells or smoke come from the unit, stop using the product. In

Esuch case, immediately disconnect the power source and contact the service center. (Continued use in such a condition may cause fire or electrical shock.)

9.If this product fails to operate normally, contact the store of purchase or your nearest service center. Never disassemble or modify this product in any way. (Problems caused by unauthorized user disassembly or repairs are not covered by your warranty.)

10.When cleaning, do not spray water directly onto parts of the product.

(Doing so may cause fire or electrical shock.) Gently wipe the surface with a dry cloth. Never use detergents or chemical cleaners on the product, as this may result in discoloration of surface or cause damage to the finish.

Cautions

1.Do not drop objects on the product or apply strong shock to it. Keep away from a location subject to excessive vibration or magnetic interference.

2.Do not install in a location subject to high temperature, low temperature, or high humidity.

(Doing so may cause fire or electrical shock.)

3.Avoid a location which is exposed to direct sunlight, or near heat sources such as heaters or radiators.

(Neglecting to do so may result in a risk of fire.)

4.If you want to relocate the already installed product, be sure to turn off the power before moving or reinstalling it.

5.Install in a well-ventilated location.

6.Remove the power plug from the outlet when there is a lightning storm. (Neglecting to do so may cause fire or damage to the product.)

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received, including interference

that may cause undesired operation.

Note:

This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna

-Increase the separation between the equipment and receiver

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

-Consult the dealer or an experienced radio/TV technician for help Use of shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC rules.

Do not make any changes or modifications to the equipment unless otherwise specified in the manual.

If such changes or modifications should be made, you could be required to stop operation of the equipment.