Installing the Camera
3)Assemble the DOME COVER.(Use the L WRENCH to firmly adjust the BOLT into place to make it waterproof.)
-To change the direction of the SAMSUNG LOGO
on the DOME COVER,change the assemble location
Eof the connection rubber and turn it back into place as in the following image. (For 180 • only)
Installing the CAMERA side to a PIPE
1.Pull the power cable and video cable from the PIPE assembly hole at the bottom of the CAMERA bottom,out through the PIPE assembly hole on the side.
1)Use a coin or slotted driver to turn the CAP BOLT assembled in the PIPE assembly hole on the side
2)Take the power cable and video cable from the PIPE assembly hole at the bottom and push the cables through the hole to pass through the PIPE assembly hole on the side.
3.Use a coin or slotted driver to turn the CAP BOLT previouslydisassembled from the CASE clockwise to reassemble it.
(Check to see if the O RING (P22 T2.4)
is attached to the | E |
If there is no O RING, the product will not be |
|
| |
properly waterproofed and may malfunction.) |
|
4.Rearrange and pull the connected power cable and video cable into the PIPE. Assemble
the screw helix (3/4" threaded)for the PIPE assembly of the CAMERA and screw helix (3/4" threaded)for the PIPE and fix the SET.
(* Completely wrap the screw helix area of the PIPE with TEFLON TAPE to make it waterproof. Make sure the cable does not get caught in the tape.)
5.Adjust the LENS in the direction you want.
(For more information on adjusting the LENS, disassembling the DOME COVER and assembly methods,please refer to 'Installing the CAMERA bottom to a PIPE'in section no.3.)
18 | 19 |