Preparing Cables
The following cables are required to install and use the Camera.
Installing the Camera
Installing on a PIPE (for SCC-C9302P)
Power Adapter Cable
EThe power adapter that plugs into the Camera’s power input receptacle has the rated volt- age of DC 12V 600mA or AC 24V 300mA.
Video Cable
The cable that connects the video output terminal of the Camera to the monitor is a BNC cable.
1.Carefully read the 'Before Installation'section before starting installation. - All holes that are not used for installation must be closed up with the
SCREWs provided in your ACCESSORY set as described in the |
|
installation HOLE section. | E |
Installing the CAMERA bottom to a PIPE
2.Connect the power cable and video cable,
and then pull them into the PIPE. Assemble the screw helix (3/4" threaded)for the PIPE assembly of the CAMERA and screw helix (3/4" threaded)
forthe PIPE and fix the SET. (* Completely wrap thescrew helix area of the PIPE with TEFLON TAPE to make it waterproof.Make sure that the cable does not get caught in the tape.)
3.Adjust the LENS in the direction you want.
1)Disassemble the DOME COVER with the L WRENCH provided in your ACCESSORY set.
(Rotating clockwise will close the cover and rotating
2)Adjust the LENS in the direction you want.
Horizontal rotation | Vertical rotation | Backlash :Widen and lift the wings on both sides of the COVER outwards to remove the COVER, |
|
| and then rotate the LENS.After finishing adjustment,reassemble the COVER by |
|
| pushing it in until a click is heard. |
16 | 17 |