Door Latch Assembly Installation Instructions
INSTALLATION
IMPORTANT: Disconnect power from machine before starting this procedure!
1.Remove the top cover of the machine. A. Remove two screws from rear of top.
B.To remove cover open door and pull cover forward.
FIGURE 2
2.Remove the side panel of the machine. A. Remove latch cover plate.
NOTE: When reassembling latch guard use the #8 PLASTIC screws supplied.
FIGURE 3
B. Remove 2 screws holding splash guard.
FIGURE 4
C.Remove one screw from lower rear on right side panel.
FIGURE 5
D. Slide panel forward to remove.
NOTE: Do not loose plastic spacers located on panel clips.
FIGURE 6 | FIGURE 7 |
|
Publication Number: 729011146INS | - 2 - | © 2004, IMI Cornelius Inc. |
