Door Latch Assembly Installation Instructions
C. Route wires in existing cavity and reinstall insulation putty and replace tape.
FIGURE 20
D.Replace side panels by sliding panels for- ward to engage panel tabs. Make sure plas- tic spacers are located on panel clips before assembling. Replace all screws that were previously dissembled.
FIGURE 21
E. Replace latch cover plate.
NOTE: When reassembling latch guard use the #8 PLASTIC screws supplied if holes are stripped.
FIGURE 23
FIGURE 22
THIS COMPLETES THE LATCH ASSEMBLY PROCEDURE. If the machine is to use OPTION 1 “DOOR RESET OPTION” allowing sold out to function complete the procedure by replacing all machine covers and guards.
IF OPTION 2 IS SELECTED CONTINUE WITH PROCEDURE
6.Installing sold out defeat jumpers.
A.Remove screw, holding electrical box to frame.
B. Pull control box from machine.
FIGURE 24 | FIGURE 25 |
© 2004, IMI Cornelius Inc. | - 5 - | Publication Number: 729011146INS |