Before Installation, Installation Example

Before Installation

-Make sure the installation location can support over 5 times (approx.5.5 kg)the total weight of the ANTI VANDAL DOME CAMERA (SCC-C9302P).

E- Be careful not to let the cable be jammed in inappropriate places or to let the insulation covering of the cable peel off during installation.

This may result in malfunction or a fire hazard.

-Items may fall and may cause hazards while installing the product.Therefore ensure that no-one is beneath the installation location. Move valuables to a safe place before installation.

Installation Example

-Able to install on ceilings.

-Directly install on a PIPE coming down from the ceiling.

-Directly install on walls.

-Directly install on a PIPE coming out from a wall.

-Install on walls, corners in buildings, columns and other locations using the

WALL MOUNT ADAPTOR (SADT -102WM), CORNER MOUNT ADAPTOR (SADT-110CM)and POLE MOUNT ADAPTOR (SADT-100PM).

(The above ADAPTOR types are sold separately.)

a.Wall Mount Adaptor (SAD-102WM)

b.Corner Mount Adaptor (SADT-110CM)

c.Pole Mount Adaptor (SADT-100PM)

Description of Installation HOLEs

A : Use when directly installing on the ceiling or a wall.
- Waterproofed only when the SCREW -MACHINE (M5 X L6...)is closed
up when not in use.	E
B : Use when directly installing on the JUNCTION BOX	E

-SCC-C9302P can be assembled into a 4 1/8" DIAMETER ROUND TYPE JUNCTION BOX.

SCC-C9302F is assembled outside of the 4 1/8" DIAMETER ROUND TYPE EXTENSION BOX,and then must be covered with the GASKET and COVER.

(JUNCTION BOX,GASKET and COVER are sold separately.)

C : Use when installing the WALL MOUNT ADAPTOR (SADT - 102WM)

-Waterproofed only when the SCREW -MACHINE (M5 X L6...)is closed up when not in use.

SCC-C9302P bottom

SCC-C9302F bottom

A	A
B	B
B
C

To additionally connect the ALARM CABLE,remove the rubber stopper,pass the cable through the hole and connect.

- The rubber stopper attached to the ALARM CABLE must be properly set onto the CASE to make it waterproof.