RF-Link Technology AWS-5832-VSR user manual Change Network Settings by Ipscan

Page 14

CHANGE NETWORK SETTINGS BY IPSCAN

The IP address is 169.254.100.100, if there is no DHCP server on your network.

Double click to change network setting.

You can double click a specific IP address and change some basic network parameters. A dialog box will appear as follows.

Change any settings you want to make and make sure you have correct values in all fields. Click Apply.

Within 10 seconds, the dialog box should disappear to indicate new

14

Image 14

Contents AWS-5832-VSR About this document Table of Contents Periodic Timer Motion Detection Product Overview Product CD Housing and Connectors Page Back side look Page Factory Setting Initial IP Address Install Ipsurveillance Application SoftwareConnecting to Network Which Browser to USE?Using Ipscan Double right click Change Network Settings by Ipscan Page Access Wireless Video Server BrowserInstall and RUN Activex Control Initial Username & Password Viewing and OperattingViewing Area Operating Area Control Panel Settings PALWEB Interface Settings Status Network Static IPDynamic IP PPPoE Settings Video Settings VideoWhen choosing Mjepg streaming, only support I Only mode Color Settings Video PreviewEvent Rule MAX Client LimitEvents Handled PTZModifying Rule Lists Actions TriggeredRule Lists ADDING/DELETING Capture Date & Time OSD Dwell Mode Setup ATUO-SCAN Mode PTZ Control PortWeb Ddns IPv4 DdnsMail Smtp Settings SMTP/FTPFTP Settings Trigger Setup Periodic TimerMotion Detection Page PRE/POST Setting Account Security „ High Maintenance Firmware updateFactory Default No Software Installation Required Supported OSSteps for Using USB config port Windows XP PC Page Static / Dhcp / PPPoE