RF-Link Technology AWS-5832-VSR user manual Steps for Using USB config port Windows XP PC

Page 51

STEPS FOR USING USB config port (Windows XP PC)

1.Disconnect power cable connected to Wireless Video Server.

2.Use mini-USB cable and connect appropriate end to USB config port and connect other end to PC USB port.

3.After 5 ~ 10 seconds depending on how fast your PC is, you can notice “Disk drive” being detected.

4.A POP-UP dialog shows “Config Wizard” is ready to run. Press OK.

Double click Config Wizard. You will see a screen as follows.

51

Image 51

Contents AWS-5832-VSR About this document Table of Contents Periodic Timer Motion Detection Product Overview Product CD Housing and Connectors Page Back side look Page Which Browser to USE? Install Ipsurveillance Application SoftwareConnecting to Network Factory Setting Initial IP AddressUsing Ipscan Double right click Change Network Settings by Ipscan Page Browser Access Wireless Video ServerInstall and RUN Activex Control Viewing and Operatting Initial Username & PasswordViewing Area Operating Area PAL Control Panel SettingsWEB Interface Settings Status Static IP NetworkDynamic IP PPPoE Settings Video Video SettingsWhen choosing Mjepg streaming, only support I Only mode Video Preview Color SettingsMAX Client Limit Event RulePTZ Events HandledActions Triggered Rule Lists ADDING/DELETINGModifying Rule Lists Capture Date & Time OSD Dwell Mode Setup ATUO-SCAN Mode Port PTZ ControlWeb IPv4 Ddns DdnsSMTP/FTP Mail Smtp SettingsFTP Settings Periodic Timer Trigger SetupMotion Detection Page PRE/POST Setting Account Security „ High Firmware update MaintenanceFactory Default Supported OS No Software Installation RequiredSteps for Using USB config port Windows XP PC Page Static / Dhcp / PPPoE