Kenwood VR-2000 Code selection after mode download, To delete a setup code, End of operation

Code selection after mode download

After successful completion of the download, step [] of the previous page, the remote control automaticafly enters a special set-up mode which works as described bePow,

DSelect the input and component names that you want to assign a setup code.

O Select the input name by selecting the "_ "or "_) " icon on

both sides of "Selector" (input selector).

This changes the section of "Video1" in the figure,

_) Select the component name by selecting the "_ "or "_) "

icon on both sides of "Device" (component connected to the

rear panel input jacks),

This changes the section of "VCR" in the figure.

_) Select the "Next" icon,

The "Register Info,2" menu screen appears.

_'_ Find out the numeric icon that outputs the power code of the component.

• Find the code with which "Device" of [] can be operated

O Select the "_" icon to output its power code.

• After selecting a numeric [con, be sure to press t_"e Joy stick key to output its power code

O Select numeric icons in order from" C_} "until the compo- nent selected in step [] is turned ON Ii.e. repeat step O for each numeric icon),

Make sure that the component is turned on.

O Select the "Entr" icon.

Select

the

"_"

icon

to output

the power

code

of the

first component

on

your

Jist in

step

n

of the

previous

page Continue to select

icons

"_"

through _(_"

until the

component

you

want

to register

turns

or_.

Though

the

"Futureset"

memory

in your remote

control

is quite

large, only

20

different

devices

power

codes

can be put o_ the keypad

at

any

one time.

if

you

require

a larger

download,

the standard

setu#

procedure

can

be

used

See

"Assigning

the

connected components

to

the

selected

inputs",

your

customer

service

representative

can

supp(y you

with

the

downloaded

setup

codes =qumbers.

_l Set up all the downloaded codes.

			• The setup	code for the	test power code to be	sent	in	step I_ is
I	Repeat the operations	of steps irl and _.	automatically	registered	at the ocatJon selected	in	step	Ill	J

_ End of operation.

To delete a setup code

•"#gO00" is displayed when the setup code is _nputteo while the "Setup IR" menu screen is shown.

{The nput number s not shown.)

•When a setup code has been downloaded, the section where

"#0000" is shown above displays "# .... ". iThe number input in step I_1s not shown.)

When setup codes of more than one components have been

downloaded, note that atl of the codes are interrelated between

each other Therefore, if any of them is deleted, you should

perform the procedure of "Setup of components which are not listed in the Setup Codes chart" from the beginning

Operation for displaying the menu screen shown on the left : O Select the "Main Menu" icon,

Select the "Stp" icon,

0 Select the "IR" icon.

Operation for deleting a setup code :

€) Select the component to be deleted,

Select the component with the "{_ "or "{_ " icon. O Select the 4 digit code "9999".

O Select the "Entr" icon.