Philips CMQ205/00 user manual Connect speakers, Connect car audio, Connect power

Page 6

Connect speakers

Note

Use speakers with an impedance of 2 to 8 ohm (4 to 8 ohm when used as a bridged amplifier).

Match the “left”, “right”, “+” and “-” terminals correctly. Revised polarity may degrade sound quality.

Option 1: Stereo mode: connect 2 speakers

(30A)

4 ohm

4 ohm

speaker

speaker

Option 2: Mono bridged mode: connect 1 speaker

(30A)

4ohm speaker

Option 3:Tri-mode: connect 3 speakers

 

(30A)

4 ohm

4 ohm

speaker

speaker

8 ohm speaker

Connect car audio

Option 1: Line input connection

English

 

Connect the amplifier to the car audio with an

 

RCA cable (not supplied).

 

Car audio unit

LINE OUT

Option 2: Line output connection Connect the amplifier to another amplifier.

Connect power

1Make the power connection as illustrated below:

Connect the ground wire from the car to the GND socket.

Connect the remote wire from the car audio to the REM socket.

With this connection, you can turn on/off the amplifier with the car audio.

Connect the power wire from the car battery to the +12V socket.

EN 7

Image 6
Contents Register your product and get support at Contents Safety Koninklijke Philips Electronics N.V. All rights reservedIntroduction Your car powerAmplifier What’s in the boxInstallation Mount the amplifier in carMount the unit with the supplied screws Connect power Connect speakersConnect car audio Less than 450mm 18 Fuse 40A +12V car battery To a metal point of the car Remote output Car audio unitUse your power amplifier Product information Replace fuseTroubleshooting Sound is too lowAlternate noise is heard