3 Get started
Caution
•Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model and serial number of your apparatus.The model number and serial number are on the bottom of your apparatus.Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Note on the power supply lead (yellow)
•When you connect other devices to this apparatus, ensure that the rating of the car circuit is higher than the total fuse value of all the connected devices.
Notes on speaker connection
•Never connect speaker wires to the metal body or chassis of the car.
•Never connect speaker wires with stripes to one another.
Overview of parts
These are the supplied parts needed to connect and install this unit.
ab
Install the car audio
These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer.
Caution
•This unit is designed for negative ground (earth) 12 V DC operation only.
•Always install this unit in the car dashboard. Other locations can be dangerous as the rear of the unit heats up during use.
•To avoid
•Ensure that you connect the yellow and red power supply leads after all other leads are connected.
•Ensure that all loose leads are insulated with electrical tape.
•Ensure that the leads do not get caught under screws orin parts that will move (e.g. seat rail).
•Ensure that all ground (earth) leads are run to a common ground (earth) point.
•Use only the supplied mounting hardware for a safe and secure installation.
•Improper fuses can cause damage or fi re. When you need to change the fuse, consult a professional.
c d e
f
aCarry case with front panel stored inside
bTrim plate
cStandard connector
dRubber cushion
eRemoval keys x 2 pcs
fScrew x 5 pcs
10EN