Philips MCD2160 user manual Get started, Prepare the remote control, Set clock, Turn on

Open the battery compartment.

Insert the supplied AAA batteries with correct polarity (+/-) as indicated.

Close the battery compartment.

4 Get started

Caution

•• Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

Always follow the instructions in this chapter in sequence.

If you contact Philips, you will be asked for the model and serial number of this apparatus.The model number and serial number are on the back of the apparatus. Write the numbers here: Model No. __________________________

Serial No. ___________________________

Prepare the remote control

Caution

•• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire.

•• Risk of decreased battery life! Never mix different brands or types of batteries.

•• Risk of product damage! When the remote control is not used for long periods, remove the batteries.

To insert the remote control battery:

1

2

3

a b c

Set clock

1 In standby mode, press and hold CLOCK SET on the remote control for more than two seconds.

	»»[24H] or [12H] hour format is
2	displayed.
	Press	/	(or +/-) to select [24H]
	or [12H] hour format, and then press
	CLOCK SET.
	»»The hour digits are displayed and begin
3	to blink.
	Press	/	(or +/-) to set hour, and then
	press CLOCK SET.
	»»The minute digits are displayed and
4	begin to blink.
	Repeat step 3 to set minute.

Note

•• If no button is pressed in 90 seconds, the system exits clock setting mode automatically.

Tip

•• You can view clock information in Eco power mode by pressing CLOCK SET.

Turn on

Press .

»»The unit switches to the last selected source.

Switch to standby mode

Press again to switch the unit to standby mode.

»»The clock (if set) is displayed on the panel.

Switch to ECO standby mode:

Press and hold for more than two seconds.

»»The display panel is dimmed.

EN 10