ADJUSTMENTS cont.
BASS SHAPER BOOST AND EQ
The optimum setting for this feature will vary depending upon the low frequency response of the vehicles interior. Set the “Boost” control half way between 0dB and +18dB. Starting from the preset frequency, gradually adjust the “Frequency” control downward or upward until you get a smooth even bass response. Once the frequency has been chosen, you may increase or decrease the equalization by adjusting the “Boost” control upward or downward.
NOISE CHECK
•Before mounting the XM6 crossover and the other audio components permanently, please conduct the following noise check:
•Start the engine and turn on the power of the source unit.
•Rev the engine and vary the audio volume to check for radiated engine noise. If there is an alternator whining noise or
•If no unwanted noise is detected, double check all the wiring and cables for safe placement. Then securely tighten the mounting screws of all the audio components.
WWW.COUSTIC.COM
SPECIFICATIONS
XM6 — 2-/4-/6-CHANNEL 2-/3-WAY CROSSOVER
Dual High Pass Crossover: | 18dB/Oct |
Frequency Multiplier: | x20 (18dB/Oct |
Band Pass Crossover: | 18dB/Oct |
| 18dB/Oct |
Low Pass Crossover: | 36dB/Oct Mono |
Bass Drive: | 0dB to 18dB |
Bass Shaper Eq: | 40Hz to 100Hz |
Bass Shaper Boost: | 0dB to 18dB |
Phase Switch: | 0˚/180˚ |
Max Input/Output: | 8Volts RMS |
Input current: | 1 amp max. |
Frequency response: | |
| ±1⁄4dB before crossover limit |
Separation: | 60dB |
THD+N: | <0.1% |
Signal to Noise: | >90dB |
Input Impedance: | >10k Ohms |
Output Impedance: | 50 Ohms |
Dimensions: | 23⁄16” H x 81⁄2” W x 67⁄8” L |
| (55mm x 216mm x 174mm) |
Due to continual product development, all specifications are subject to change without notice.
23