Coustic owner manual XM6 Controls & Indicators, Equalization point between 40Hz 100Hz

Page 5

12

11

13

15

21

19

21

WWW.COUSTIC.COM

XM6: CONTROLS & INDICATORS

11

Parallel Input Switches – “IN”: Each appropriate switch must be set

 

to the “IN” position when the source unit does not supply rear or

 

subwoofer channel outputs. “OUT”: If the source unit has independent

 

front, rear and/or sub channel outputs, set each switch to the “OUT”

 

position

12

High-Pass Frequency Selectors – For selection of high-pass crossover

 

frequency between 40Hz and 400Hz, 18dB/Octave

13

Frequency Multiplier – To change selected high-pass crossover

 

frequencies from 40Hz - 400Hz, to 800Hz - 8000Hz, 18dB/Octave

14

Band Pass Switch – Positioning this switch to the “IN” position reconfig-

 

ures the “B” channel from a high pass output to a band pass output.

 

When the “IN” position is selected, the band pass frequency selector is

 

engaged.

15

Band Pass Frequency Selector – For selection of the top crossover point

 

of the band-pass frequency range between 300Hz and 3kHz,

 

18dB/Octave. (The high pass frequency selector must be used to

 

select the bottom crossover point for the band-pass frequency range.)

 

The full band pass frequency range is 40Hz to 3kHz, 18dB/Octave.

16

Subwoofer Frequency Selector – For selection of the low-pass crossover

 

frequency between 40Hz and 200Hz, 36dB/Octave

17

Bass Shaper Frequency Selector – For selection of low frequency

 

equalization point between 40Hz - 100Hz.

12

14

11

19

18

Bass Shaper Boost Level Control – For adjusting the Bass Shapers

 

selected equalization frequency level with a maximum boost of 18dB

19

Phase Control Switch – Positioning the switch to the “180”

 

position shifts the right output signals on channels “A” and/or “B”

23

20

 

16

22

17

18

 

XM6 CONTROL PANEL

 

180 degrees out of phase relative to their left output signals

20

Sub Phase Control Switch – Positioning the switch to the “180”

 

position shifts the subwoofer output signals 180 degrees out of phase

 

relative to channels “A” and “B” output signals

21

Independent Output Level Controls – Independent left and right output

 

signal level adjustments can be made for accurate stereo balance and

 

imaging

22

Subwoofer Output Level Control – For adjusting the low pass output

 

signal level

23

Power Indicator – This indicator lights up when the internal switching

 

power supply is activated and the unit is operational

9

Image 5
Contents Page Welcome Features XM6 Terminals Equalization point between 40Hz 100Hz XM6 Controls & IndicatorsPreparation InstallationLocation MountingSee XM6 Phase Adjustment See XM6 Phase Adjustment Audio Input Connections WiringAudio Output and Power Connections Adjustments XM6 Phase Adjustment XM6 2-/4-/6-CHANNEL 2-/3-WAY Crossover SpecificationsNoise Check Limited Warranty Troubleshooting GuideWarranty Page South 46 STREET, Suite 2020, PHOENIX, AZ