Place Your System, Subwoofer | Boston Acoustics Model 25 specification

Subwoofer

TVee® Model 25		22
	WIRELESS ID
		4 3 2 1
0.5A	23	24	25	26
230V~
50Hz

VOLUME

POWER

MIN MAX

22Wireless ID Switch – Selects the “channel” for the wireless subwoofer signal. Set in the same position as 11 (see previous page).

23Volume – Adjusts the volume of the subwoofer for best balance with the soundbar.

24Status Indicator – Lights green when the subwoofer is active and red when it is standby mode.

25Power On/Off Switch – Turns the TVee subwoofer on or off. Normally it is left on all the time.

26Power Cord– Plug it into an AC outlet.

Place Your System

Decide on the location and position of the system before making any connections.

Soundbar Location

Place the soundbar on a table surface or shelf near the television, or wall-mount the soundbar above or below the television.

Keyhole mounts on the rear of the soundbar permit wall mounting.*

Wall-Mounting

The TVee Model 25 soundbar can be wall-mounted using the integrated keyhole mounts. A mounting template can be found in the inner flap of the product carton. Using a level tool, position and tape the template to the wall in the desired location. The template is designed to allow enough room for the grille and keyhole mounts when the soundbar is mounted below a TV.

Install hardware* using the template as a guide and then remove the mounting template from the wall. Connect your audio and power cables prior to mounting the soundbar on the wall. Place the grille on the soundbar after mounting.

*Consult a person knowledgeable about your wall type to recommend suitable hardware for hanging the speaker. You can remove the rubber feet before hanging the speaker on the wall. Usually it is best to leave soundbar off the wall until connections are made.

	Set the rear panel LOCATION 12 switch to match how the soundbar is placed. Use WALL	LOCATION

	for wall mounting and TABLE for placement on a shelf, cabinet, or table.
		TABLE WALL
		TABLE WALL