Dual XOBP12D owner manual Installation, Before installation, please review the following rules

Page 3

XOBP12D INSTALLATION

Installation

The following installation instructions are very basic. If you feel unsure about personally installing this speaker system, Dual recommends aquiring the services of a professional car audio installation center.

Before installation, please review the following rules:

1.Be sure to carefully read and understand the instructions before attempting to install this product.

2.For safety, disconnect the negative terminal from the battery prior to beginning the installation.

3.For easier assembly: If additional wiring is required, we recommend

running all wires prior to mounting your speaker in place.

4.Use the highest quality connectors for a reliable installation and to minimize signal or power loss.

5.Use caution before you drill or cut! Be careful not to cut or drill into gas tanks, fuel lines, brake or hydraulic lines, vacuum lines or electrical wiring when working on any vehicle.

6.Never run speaker wires underneath your vehicle. Running speaker wires inside the vehicle provides the best protection from exhaust heat and environmental elements.

7.Avoid running wires over, near, or through sharp edged surfaces. We suggest you also use rubber grommets to protect any wires routed through metal, especially the firewall.

8.When running the speaker cable from the amplifier, avoid running it near sources of high current (i.e. wiring harnesses, battery cables).

9.Amp connection: The positive (+) speaker output from the bass amp connects to the positive (+) terminal, and the negative output (-) connects to the negative (-) input terminal on the input cup located on the rear of

the subwoofer enclosure. DO NOT CONNECT AMP OR ANY AUDIO SOURCE TO ILLUMINATION INPUTS AS DAMAGE TO LIGHTS WILL OCCUR.

10.Illumination connection: The positive (+) output from your 12V system connects to the positive (+) input, and the negative (ground) connects to the negative (-) input on the input cup located on the rear of the subwoofer enclosure. Improper 12V polarity will not cause damage to the lights, but they will not illuminate.

3

Image 3
Contents Page Getting Started SafetyBefore installation, please review the following rules InstallationEnclosure Guidelines IlluminiteTM Lighting Hook-Up Recommendations General Features What to do? Limited One-Year WarrantyDual Electronics Corp. NSA0106-V01