Kenwood TM-V708A Programmable Function PF Keys, PF PF1, MR PF2, VFO PF3, Call PF4

PROGRAMMABLE FUNCTION (PF) KEYS

The Programmable Function keys, [PF], [MR], [VFO], and [CALL], are located on the front of the microphone. These keys have the following default functions:

[PF] (PF1)	Band Select
[MR] (PF2)	Memory Recall
[VFO] (PF3)	VFO Select
[CALL] (PF4)	Call Channel Select

If desired, you can change the defaults to the following key functions:

	Key Function	Ref.	Key Function	Ref.	Key Function	Ref.
		Page		Page		Page
	A/B	17	MHz	20	C. IN	37
13	MONITOR	19	TONE	28, 53, 55	LOCK	65
	ENTER	28, 35,	REV	31	T. SEL	28, 53, 55
		54, 61
	VOICE	77	LOW	21	SHIFT	27
	1750	30	MUTE	69	STEP	62
	PM	42	CTRL	17	VISUAL	46
	MENU	22	PM IN	42	DIM	63
	VFO	15	A.B.C.	64	SUB-BAND SEL	17
	MR	35	MsV	38	PWR	19
	CALL	37	M. IN	34	(PF1only)

1Press [MNU] to enter Menu mode.

2Press [c]/ [d] to select “MIC (1–8–)”, then press [OK].

3Press [c]/ [d] to select “PF1 (1–8–1)” to “PF4 (1–8–4)”, then press [OK].

4Press [c]/ [d] to select your desired function.

5Press [OK] to complete the setting.

6Press [MNU] to exit Menu mode.

Alternatively, you can skip steps 1 to 3. With the transceiver power OFF, press and hold the programmable function key you want to program (PF1 ~ PF4) while turning the transceiver power ON. Continue from step 4 to program the key.

Note:

◆Without an optional VS-3 unit installed or with OFF selected in Menu 1–2–4 (VOICE), pressing the PF key programmed with Voice causes the transceiver to announce the current frequency using beeps of different frequencies.

◆To restore the default functions, perform a Full Reset {page 39}.

60