Rockford Fosgate Active Crossover Mode Selections for the 2600X, Crossover Frequency Settings

ACTIVE CROSSOVER MODE SELECTIONS FOR THE 2600X AND 4600X

The Series 1 2600x and the 4600x amplifiers feature a selectable electronic crossover. One module controls two output channels that can be configured in a High-Pass, Low-Pass, or Full Range (factory default) position. (Note: The 4600x has 2 modules as it is a 4-channel amplifier). Selection is made by positioning a removable module card. Both the 2600x and 4600x are shipped with 100Hz 12dB per octave Butterworth aligned crossover modules. Additional crossover frequency modules are available from your Authorized Rockford Fosgate Dealer.

Note: The factory default setting is Full Range.

CROSSOVER FREQUENCY SETTINGS

To change the crossover mode, remove the crossover module from the housing. Rotate the module to the desired setting and gently push the module back into the amplifier housing as shown on the diagram on the back of the amplifier.

Example: The 2600x is shipped with a 100Hz module. With the module in the Full Range setting, the amplifier will pass through all 20Hz - 20kHz frequencies.

In the Low-Pass setting, only those frequencies below 100Hz will pass through the amplifier.

In the High-Pass setting, only those above 100Hz will pass through the amplifier.

– 10 –