VCR/DVD Punch-through
Your RCU807 punches through the six transport keys (REVERSE, PLAY, FORWARD, RECORD, STOP and PAUSE) to VCR or DVD Mode, whichever was used most recently. Punch-through to VCR or DVD transport keys is only allowed for TV, VCR, DVD and CABLE Modes. The SAT and CD/AUDIO transport keys are dedicated to their programmed modes.
The LCD shows component changes for the VCR or DVD Punch-through keys if they are pressed in other modes (e.g., If you are in CABLE Mode and you press and release PLAY, either VCR or DVD is displayed in the LCD).
Record Key
In the VCR and AUDIO/CD Modes (including Punch-through), the RECORD key must be pressed twice before the command is sent. This is also true if a VCR component is programmed under any other mode. The exceptions are for TV, DVD, CABLE and SAT codes, where the RECORD key transmits the command after only a single RECORD keypress.
Additional Features
Set Time for LCD Display
You can set the time the LCD displays. To set the time for the status display, follow these steps:
1.Press and hold the SETUP (S) key for 2-3 seconds until the LCD display shows the Setup Mode? Screen.
2.Release the SETUP (S) key.
3.Press and release the SETUP (S) key repeatedly until the Clock Setup Screen 1 appears.
4.The cursor under the Hours digits (HH) will be flashing. Press and release the LEVEL+/UP ARROW or LEVEL-/DOWN ARROW keys to select the hour. Press and release the ENTER key once you have reached the correct hour.
Note: To adjust the AM/PM designation, repeatedly scroll through the hour settings.
5.The cursor under the Minutes digits (MM) now flashes.
Press and release the LEVEL+/UP ARROW or LEVEL-/DOWN ARROW keys to select the minutes. Press and release the ENTER key once you have reached the correct minute setting. The LCD display shows the Success Screen, then returns to the normal time display. The time setting is now complete.
