Specification
1. GENERAL
Power Supply Requirements DC 12 Volts, Negative Ground
Chassis Dimensions 178(W)x160(D)x 50(H)
Tone Controls |
|
- Bass (at 100 Hz) | ±10 dB |
- Treble (at 10 kHz) | ±10 dB |
Maximum Output Power 4x60 watts
Current Drain
15 Ampere (max.)
2.DVD PLAYER
Signal to Noise Ratio
>55 dB
Channel Separation > 40 dB
Frequency Response
20Hz - 20 KHz
3. RADIO
FM
Frequency Coverage
FM: 87.5 - 107.9 MHz
IF
10.7 MHz
Sensitivity (S/N=30dB) 4μV
Stereo Separation >25dB
AM
Frequency Coverage
530 - 1710 KHz
IF
450 KHz
Troubleshooting
If it appears that your DVD unit is faulty, first consult this checklist. It may be that something simple has been overlooked.
Under no circumstances should you try to repair the player yourself, as this will invalidate the warranty. Only qualified service personnel can remove the cover or service this player.
No Power
If the power supply is connected to the car accessory circuits, but the engine is not moving, switch the ignition key to “ACC”.
Check if the fuse is blown. Then replace the new fuse.
Check if the on/off button on the front of the player is set to on.
No Picture
Check if the monitor or TV is switched on.
Check if select proper mode, such as Disc Play mode and AV mode.
Check the video connection.
Distorted Picture
Check the disc for fingerprints and
clean with soft cloth, wiping from centre to edge.
Sometimes a small amount of picture distortion may appear. This is not a malfunction.
Completely Distorted Picture
The disc format is not according to the
No Color in Picture
The disc format is not according to the
Disc Does Not Play
Ensure the disc label is upwards.
Clean the disc.
Check if the disc is defective by trying another disc.
17