Applications, Fuse, IEC Power Cord Connection

Applications

Aside from it’s primary use as a floor monitor, the Peavey PV®15 PM has a variety of applications such as sound reinforcement, public address, side fill system, karaoke or musical playback. A typical signal source for the line-level inputs of the Peavey PV®15 PM would be a sound reinforcement mixing console (mixer) or the output from a CD player, iPod player or tape deck. A dynamic microphone can be connected and used as well.

B O T T O M P A N E L

FUSE

The unit is AC power line fuse protected from overloads and fault conditions with a fast-blow 3.15 Amp fuse. This fuse is located within the enclosure. If the fuse fails, THE FUSE MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PREVENT VOIDING THE WARRANTY. If the unit blows a fuse, it should be taken to a qualified service center for repair.

1IEC POWER CORD CONNECTION

This receptacle is for the IEC line cord (supplied) that provides AC power to the unit.

It is very important that you ensure the PV® 15 PM has the proper AC line voltage supplied. You can find the proper voltage for your PV® 15 PM printed next to the IEC line (power) cord on the rear panel of the unit. Please read this guide carefully to ensure your personal safety as well as the safety of your equipment.

Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always be sure that the mixer and all other associated equipment are properly grounded.

2 ON-OFF SWITCH

This rocker switch supplies AC power to the PV® 15 PM when switched to the ON position.